answersLogoWhite

0

What does a speed sensor do in a 1999 Chrysler lhs?

Updated: 8/18/2019
User Avatar

Wiki User

13y ago

Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What does a speed sensor do in a 1999 Chrysler lhs?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is an input speed sensor on a 1999 Chrysler lhs?

It is a sensor on the transmission that reads the rotational speed of the input shaft.It is a sensor on the transmission that reads the rotational speed of the input shaft.


Where is the speed sensor on a Chrysler lhs?

Driver side of the transmission case, there are two.


How do you install mass airflow sensor on a Chrysler lhs?

A Chrysler LHS does not have a mass airflow sensor.


What is the transmission range sensor on a 1999 Chrysler LHS?

It is the sensor in the transmission that reads the shifter position and transmits it to the transmission computer.


Is there a diagram of the 1999 Chrysler lhs engine?

Where is the thermostat located at on a 1999 lhs


Where is the speed sensor located on a 1996 chrysler lhs?

The vehicle speed signal comes from the transmission output speed sensor, driver side of the transmission. It is the rear most two wire sensor.


1994 Chrysler LHS died on the road and now does not want to start why?

how do you install a crankshaft sensor on a 94 Chrysler lhs....where is it located on a 94 Chrysler lhs???????????????????loisanne0@hotmail.com


How do you locate the door ajar sensor on the rear driver side latch on a 1999 Chrysler LHS?

It is inside the latch itself.


What is the cost of a faulty speed sensor on a 2000 Chrysler lhs?

the cost is under 20 bucks Autozone part # SU1034,


How do I replace an AC belt on a 1999 Chrysler LHS?

will chrysler lhs not run wen ac belt is broken


Where is the fuel pump on a 1999 Chrysler LHS?

The fuel pump on a 1999 Chrysler LHS is inside the fuel tank. The tank needs removed to access the pump.


1999 Chrysler LHS input output speed sensors have had to replace three times recently twice in the last ten days Getting expensive what is happening?

I would expect to find a loose wire in the connector for the output speed sensor.