Want this question answered?
Yes, it can.
it depends on the needle.
The needle of a clock is referred to as a hand.
A needle sink in water.
You need to rub the needle with a magnet or you can use coil around the needle and pass current to make it a electro magnet.
by simple moving of its needle,or by change the direction of needle.
If the needle is out you have to replace the needle itself as its an LED light. If its a dashboard light then you have to remove the face plate(two screws on the top of it) and take out the instrument cluster, take it apart and replace the bulb. Although the needles are engineered to be removed/replaced, you cannot buy a single needle. You must by the entire instrument cluster to fix this.
It is not possible to fix a broken needle. You must remove the broken one and replace with a new needle.
Needle have one eye but can't see.We say the hole at the top of needle is the eye of the needle.
If you have floated a needle on the surface of the water in a glass then adding a little detergent will cause the needle to sink. This is because the presence of the detergent changes the surface tension of the water so that it can no longer support the needle.
Needle have one eye but can't see.We say the hole at the top of needle is the eye of the needle.
it's a needle!
A needle has an eye but can't see.
To dispose of a needle it is important to slide the cap back over the needle and put the needle recycle bin. The bin is locked with a small opening so people cannot reuse the needle. To activate the needle sticks remove the cap from the needle.
i dont know if it is correct but i think it is a needle.
Yes, it can.
replace the inlet needle and seat. If you cant replace the seat then clean with a q- tip.