This means you have excessive oil (Quanity) the crank case is over filled. Check the oil level with the dip stick, Make sure the oil level in in between the full, and low range.
With the engine off, press and hold the odometer reset pushbutton. Start the car. Keep finger on odometer reset pushbutton until "oil life" message starts flashing. Release the button.
Code 55 is end of message ( it is done flashing codes )Code 12 is start of message or battery was disconnected.Code 55 is end of message ( it is done flashing codes )Code 12 is start of message or battery was disconnected.
turn the ignition key on make sure the odometer displays miles(not trip) push the trip reset button and hold it in turn the key off turn the key back on keep holding the button in until the flashing lines on the odometer disappear and the numbers come back.
Hold the odometer button down for about 5 seconds while you turn the key from off (position 0) to accessory (prosition 1). When you first turn the key, you will see "test 1", don't let go of the odometer reset button until the display changes and shows "reset". Once you see "reset", let the odometer button up, then press and hold it again for about 5 seconds until the "reset" starts flashing. Once it is flashing, let up on the odometer button then press it one more time. Now you should see a message that says "END SIA" and your oil service light should be reset.
BArac OBAMA
You need to hold the odometer button down for about 5 seconds when you turn the key from off (position 0) to accessory (prosition 1). When you first turn the key, you will see "test 1", don't let go of the odometer button until the display changes to show "reset". Once you see "reset", let the odometer button up, then press and hold it again for about 5 seconds until the "reset" starts flashing. Once it is flashing, let up on the odometer button then press it one more time. Now you should see a message that says "END SIA" and your oil service light should be reset. This worked for me on my 2001 330i.
if the disc reader is lighting, turn on the wii and go to the Wii Message Board it means that you have a new message
Proceed as follows to reset the service reminder indicator of your : Ignition position I Press and hold in the reset button for the trip odometer Turn the key to position II within 2 seconds. Keep holding the reset button for the trip meter pressed in until the original value has been reset. Release the reset button for the trip odometer within 4 seconds. The instrument gives an audible signal when resetting has succeeded If the trip meter is already reset the reset button should be held in for a minimum of 10 seconds and a maximum of 14 seconds. If the reset button for the trip odometer is not released within 4 seconds and before the light stops flashing, the service reminder indicator is not reset.
If the message being sent is a message of distress, or a request for assistance, then the police should be contacted quickly. If you don't know Morse well enough to extract at least a part of the message from the flashing light, then you have no basis to infer that the flashing light "looks like Morse code", and you should probably just continue on your way.
How do you reset service indicator message for A 1999 Mercedes Benz ML320 after service A or B is completed?
how can i reset the service b message on the mercedes clk 430?
a 150