answersLogoWhite

0

inside distributor under cap (expensive) Honda calls it an ignitor its part of the distributor actually it is the distributor

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

What does the fuel pump on a Honda Accord look like?

Depends on what model, and year you are asking about. 1969 HONDA ACCORD LOOKS HARD AND HEAVY!


Car code Honda accord 91491?

Looks like the radio code for a particular radio on a Honda.


What does a headlight relay switch look like on a 1987 Honda accord?

The headlight relay switch on a 1987 Honda Accord looks like a small box. The switch is located underneath the engine compartment fuse box.


Where is the ignition control module located on a 89 Subaru DL?

The book I looked in has some printing missing BUT it looks like the ignition module could be mounted below the steering column. It is in some Subaru's. Hope this helps.


How does a vacuum line diagram for a 1987 Honda accord look like?

I vacuum diagram for a 1989 Honda Accord looks visually like a maze. There are several lines going into different mechanical parts that need air to function properly.


What does the inside of the door from a 1997 Honda accord look like?

It looks like the inside of a car door. There's linkages and window tracks and stuff.


Is their a check engine light on the 2003 Honda Accord?

There is one, but it's not marked "check engine." It looks like a little engine with a lightning bolt on it.


What is the yellow light on the Honda Accord instrument panel indicate that looks like an engine?

That is the Check Engine light. It means there is a problem with the emissions system.


Where is the electronic ignition module located on a 1989 ford mustang gt?

On the distributor housing. It looks like a rectangle with an electrical plug at one end.


What do you do when there is no pressure in the clutch of a 1993 Honda Accord LX?

Check your clutch slave cylinder fluid level it looks like a mini brake fluid bottle


How hard is it to rebuild a cylinder in a Honda Accord engine?

The best to rebuild a cylinder is to rebore it. If the cylinder looks ok then just a minor hone job is required.


What does the ignition module look like in a 1991 camaro rs 5.0?

looks like an elbow that is flat two prongs on right elbow an one on left