The International Ship and Port Facility Security Code (ISPS Code)
The meaning of a particular message depends with the message of the sender to the receiver.
Compared to single-bus architecture, the using of multiple-bus architecture have a great advantage in speed and of course, will affect performance also. Instead of using single-bus architecture, it is more convenient to use multiple-bus architecture. Using multiple-bus architecture will make each device to connect to own bus, which means that each device will have its own bus. This way, it will be faster to transfer data of each devices, so the data transfer doesn't have to stuck like in the single-bus architecture where many devices are connected to a single-bus, that will eventually reach the capacity of the bus and thus will make the data "queue". Of course, it will cost more to have multiple bus, but the cost will not match the need of faster speed, compared to the one of that single-bus architecture.
In technology, the bus is used to carry data. The width of a data bus helps determine the amount of bytes that can be carried out each second.
In Morse Code, ••- is the letter U.
No CCD/bus messages received form ECM.
Controller area network(can) data bus, high speed bus(-) shorted to data bus(+) in short you have a fault in ur system
The "bus" is the communication system for the computers on the vehicle. "no bus" means that communication is not happening. It could be a computer, wiring, fuse, ground, etc issue.
Trouble code P1687 means: No Mechanical Instrument cluster bus message
bus regervation
The ccd bus is the communication system between computers on the vehicle. Open means one of the circuits has a break in the wiring.
It means that the cluster has lost its connection to the "bus"(the system the comuters use to communicate). Jeep has had some issues with the connecters for the instrument cluster.
Handicapped bus
"un bus" is a bus in French.
Unlock code for bus driver is nothing less than the software for the bus to drive. It needs a software to unlock or run the bus. If you can run it then it may be a firewall or antivirus that block the bus. Try to install the driver and if it didn't work then check firewall or antivirus if it blocks the bus or if any of the above didn't work then it will be the bus that doesn't support by the system that you are currently using. Kyndee2009
It means that either the "communications buss" or a connector has failed or the computer or some device on the buss has failed.
no bus message received from the transmission control module. The 'bus' system is the communication system the computers use to send information back and forth. Anything from a bad fuse, broken wire, or a bad computer can cause that code.