That means Nominal Diameter is 300 mm
the minor diameter should be between 4.917mm and 5.153 mm, so the largest allowable size is 5.153mm
It means that it is a six cylinder naturally-aspirated diesel engine with 125 mm piston bore
To calculate wrench size you measure across the flat surfaces of the nut or bolt, then pick a wrench marked with that size. Be careful, there are metric and SAE nuts and bolts and some wrenches are close but not right. -For instance you should not use a 1/2" wrench on a 12 mm nut. -It may look right, but will round the edges of the nut.
Probably 25 gauge, which is .556 mm thick. However, 26 gauge is close too, it is .478 mm thick.
The M5 thread specification (in mm) is as follows: Nominal diameter d = D Pitch P root radius r pitch diameter d2=D2 minor diameter d3 D1 thread height h3 H1 drill diameter mm M 5.00 0.80 0.115 4.480 4.019 4.134 0.491 0.433 4.20
Size of the bullet
70mm is the size of the print. The film is 70mm wide.
Course grained it mean more than 2 mm.
i believe you mean US sizes Diam = 20.7 mm Circum = 64.1 mm
The normal size of ovaries are the size of a Greek olive. They measure close to 30 mm x 15 mm x 15 mm in size.
12 iron is thickness, approx .25" or 6.33 mm.
its a size of a cyst or lump
show size of 8mm
DN": Diametre nominel - Nominal diameter of the valve, and "50" is the size of the valve in [mm]. Alternative is NPS (Nominal pipe size in inches).
It is 8.5 mm, of course!
52.8 mm
No