Mitsubishi Montero, Pajero, and Shogun

What does hold mean on the console of a 1998 Mitsubishi montero sport?

123

Top Answer
User Avatar
Wiki User
Answered
2009-11-15 20:50:33
2009-11-15 20:50:33

I have an '01. I use this feature during slippery weather. I believe it starts the tranny in second gear to avoid rear wheel slipping.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


how do i remove radio from 98 montero sport for #

How to change a starter on a 1998 montero sport

How to replace wiper motor on a 1998 montero sport mitsubishi

On the compressor itself. It has an L on the cap.

No but you can make one from aluminum flashing or from aluminum duct.

Should be 4 senors. 3 on driver and 1 on passanger

I couldm't find it on my mom's montero, what ever you do don't take off the big hose on the botom (IT's the transmission coolant)

Do you mean wiper arms or do you mean the wiper blade assemblies attached to the wiper arms? If assembly, then see sources and related links below for a wiper blade installation video for 1998 Mitsubishi Montero Sport (hook end arms).

Follow the top radiator hose down to the water outlet. The stat is in the water outlet. Mark

Yes, as long as it fits the space and the terminals are oriented correctly.

The horn fuse on my 2000 Montero Sport is located in the fuse box under the dash, to the left of the steering column. The fuse box cover shows a horn symbol.

The 1998 Montero Sport crankshaft sensor will be located on the rear of the engine. The crankshaft sensor is on the inside of the rear engine cover.

the firing order is 123456 1,3,5 on left side of engine from the front of the vehicle 2,4,6 on the right side of the vehicle googel (what is the firing order for a Mitsubishi montero)

It in the passanger compartment #2 and is a 10A fuse.

Depends on how hard the vehicle has been worked, but Mitsubishi service manual says the Timing Belt should be changed at 100,000 miles.

The 1998 Mitsubishi Montero Sport has the most common hook-end wiper arms. See Sources and Related Links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.

13 years so far with 200,000+ miles.

check the fuse box under the hood in the engine compartment

Try this. http://www.etrailer.com/products.asp?model=Montero&category=hitch&year=1998&make=Mitsubishi&t1=&h=e

If you remove your MAF (Mass Air Flow) Sensor, you will see there is a resistor just behind the MAF sensor on top...thats your Air Temperature Sensor.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.