Which brakes are you replacing front or rear or all four It shouldn't cost more than $100 with out parts and labor Or you can do them your self it's not that hard at all unless your are doing the rear brakes which will require a special brake spring tool
NONO
Front or rear.. disc or drum type..??????????
No , on a 1988 Mercury Sable , 3.8 V6 engine : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver
I believe that wire is for the key is in the ignition warning buzzer! Not 100%, but 90%.
http://www.coolcats.net/tech/troubleshooting/heatercore.html
Probably , there would be a fuse box in the passenger compartment and a Power Distribution Box ( which is " live " ) located in the engine compartment
If you are referring to the electric engine radiator fan, there should a safety recall for a free replacement or repair. I had one done on my 1995 Mercury Sable. But I don't know if the recall goes back that far to 1988. Go to the Federal Government's National Highway Safety web page to see.
The cast of Le sable chinois - 1988 includes: Javotte Rougerie William Zamparutti
you change the brakes,check brakes fluid,bleed the brakes why is hard to stop in a 1988 sliverado?
I would suggest you look in either a Chilton or Haynes manual for the proper steps to take to replace your car's rear brakes. There you will find instructions as well as illustrations that will help to get a proper job.
To replace the brakes on a 1988 Ford Bronco, start by safely lifting the vehicle and removing the wheel. Next, remove the caliper by unbolting it from the bracket and slide it off the rotor; support it with a bungee cord to avoid straining the brake line. Replace the brake pads and, if necessary, the rotor, then reassemble by reversing the disassembly steps. Finally, bleed the brake system to remove any air and ensure proper function before lowering the vehicle and testing the brakes.
you have to take the timing belt cover off and timing belt to get to the water pump