Want this question answered?
2008 Chevy Aveo hold 11 US gallons.
12 Gallons
why is subaru forester 1998 hold light flashing
I have a 2005 and it holds about 12 gallons.
If the hold light keeps flashing on a Kia Sportage a sensor may be malfunctioning in the light. The flashing light could also indicate that a speed sensor is going bad.
The hold light is a warning indicator. Essentially, the flashing indicates that there is an electrical problem with the transmission.
The hold light refers to the hold button on the shifter module. It means the transmission holds the lower gear revving up the rpms and won't shift to the higher gear. Seeing the light means the button has been engaged. Push it to turn it off
A steady on "Hold light" means you pressed the hold button next to the shift lever, repress to disengage. A flashing "hold light", usually accompanied by the flashing check engine light means the car is in limp mode. Limp mode stops the transmission from switching to forth gear and engages at 35 mph. Check the Manifold Absolute Pressure sensor wiring, should have 5volts between the outer two wires with ignition turned on and the middle wire to outside wire voltage should change 1-5volts when you start the vehicle, also check the vacuum line for cracks. Check the Throttle Position Sensor connector. If both are good remove the plastic cover from the top of the engine and you will see the Camshaft Position Sensor between the camshafts on a 2005 or earlier Aveo disconnect the plug check the ohm reading between the pins it should be between 460-620 ohms. If none of the above finds the problem then it probably needs a relearn procedure on the cam position sensor, this can only be done at a dealership. Disconnectinng the battery for 15 mins usually resets aveo service lights if the problem is still there the flashing hold light will come back on.
When the hold light is flashing, it means there is a problem with the transmission system. The problem can be various things including the transmission is locked in a gear and can be caused by overheating or a speed sensor problem.
Speed sensor....on transmission need changing....
the hold light on on my mazda truck b 2600 stays on or flashing and it shut the engine off
Remove the bolts that hold down the battery, remove the negative, remove the positive, and then pull it out. To install, do the following steps in reverse order.