Illumination is the ability to lighten the screen or darken the screen with the other dash lights on the vehicle. normally you will have two orange wires coming from the cars wiring harness one with a white stripe one without. The orange/white wire will make the stereo dim or brighten with the dash lights. the solid orange wire will dim/brighten the stereo with the headlights. so if it is night you will have the headlights on, when you turn the headlights on the stereo dims so the light from the stereo will not blind you at night. while the headlights are off the stereo will be bright so the stereo light will be visible in the daytime
The illumination wire on a car stereo is meant for the brightness on the display. It is used to adjust the brightness of the display for seeing it during night hours.
Tap into the dash illumination fuse in the fuse block.
Usually the "illumination" wires are yellow in the car and the stereo, and the negative should go to ground. I think that's how I hooked mine up. I can check it and get back to you later.
You connect the positive one (commonly orange/white) to your dash lights positive.
I bought a stereo to install myself. The pro-installer/salesman told me of this wire. You know how the stereo display light goes brihgt to dim when you turn on your head lights? This is a low voltage input to the stereo. Is this what you are dealing with?
2 to each speaker, 1 ground, 1 keyed power, 1 illumination or memory.
If it is an aftermarket stereo then i would say that the installer tied into the dashboard illumination or headlight power wire for 12 volt power for the stereo.
Light or illumination. \m/(>.<)\m/ Rock on!
st means stereo pan position stereo left n right =st
Shakeya means Enlightenment, Illumination, Purity.
Ronak, in Hindi means light or illumination. It could also mean happiness.
Stereo