24 valve i think
The front one
its under the car on the passenger side on the engine side of the radiator. its a inline thermostat
Of course it is bad, whether it`s humming or not.
Power supply
None. The engine is an Mazda 626 V6 2.5 L.
To connect a 240V to 24V 40VA transformer, you will typically have two input wires for the 240V side and two output wires for the 24V side. The 240V input wires will connect to your power source, while the 24V output wires will connect to the device or circuit that requires the lower voltage. Make sure to follow proper wiring guidelines and safety precautions to avoid any electrical hazards.
the stock 2.5l 24v engine only produses around 165bhp.
On the Ford Duratec 3.0 DOHC 24V engine, the ignition coils are typically numbered from left to right when viewed from the front of the engine. The numbering starts with coil number 1 at the front (closest to the timing cover) and goes to coil number 6 at the rear. This configuration corresponds to the cylinder numbering, where cylinder 1 is the frontmost cylinder on the passenger side and cylinder 6 is at the rear on the driver's side. Always refer to the specific service manual for your vehicle for precise details.
No its not. Its for 24v security cameras.
( 2 timing chains ) 1 chain to each cylinder head
under and behind the glove box hard to find but its there same as the 98-2002 euro ford cougar
You don't. 2 12v panels together don't make 24v - doesn't work that way. If you need 24v you need to get 24v panels.