0
A type of indicator of the temper (grade) of the bolt. I think 3 lines = grade 8.
other bolts use different indicators, too. on japenese bolts, sometimes a dot is used so they can count revolutions to reach desired torque of bolt without using torque wrench.
hope that helps ya.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the designation for a grade 5 bolt?
A grade 5 hex bolt has 3 radial lines formed into the top of the head. Bolt manufacturers can provide listings of bolt markings and their corresponding strength ratings.
How do you times fractions by each other?
Multiply top lines together and same for lower lines so 3/4 times 1/2 means top lines of each are 3 and 1 so 3x1 = 3 and lower lines are 4 and 2 so 4x2 = 8 then 3/4 x 1/2 = 3/8
How do you do graffiti writing on paper?
if you want to do a s you 3 lines on the top and bottomthen you join the lines together
What are the 4 methods to divide a square into 4 equal parts?
1
How do you move three lines from five squares to make 4 squares?
Move 3 lines "from" - do you mean 'remove 3 lines from' - or - move 3 lines to other places? Anyway, this all depends on the layout of the five squares.
What is the bolt pattern for a 1966 Pontiac lemans?
I'm assuming you mean the bolt pattern for the wheels?? 5 on 4 3/4.
What does it mean for three lines to be concurrent?
Concurrent lines or line segments occur when 3 or more lines meet at the same point
What company logo has 3 blue lines at the bottom and 2 arched lines at the top resembling a stairway to a building of some sort?
UNESCO
What is power lines 1 level 3?
Left 5, top center 3, right 4, top 6, center bottom 2, bottom 1.
Transmission Dipstick for 1990 Acura Integra GS?
If it is a Manual 5spd. Then their is a fill bolt and a drain bolt. The drain bolt can be only taken off with an 3/8" socket wrench. And the top fill bolt which is all next to the passenger side axle. The bolt should be a 17mm.
How do you install an alternator on a 98 dogde neon?
disconnect battery then pull off pass tire to access alternator preferably with jack stands alternator has upper bolt and lower bolt loosen lower bolt and bracket that contains 3 bolts. on top of alternator is upper bracket that holds alternator in place the tensioner is facing firewall loosen tensioner all the way out then finally loosen top alternator bolt [ the tensioner bolt actually goes through top bolt which is not visible until you take it out} disconnect alternator
The head bolt set on 1991 Pontiac 2L OHC has 3 long studs top - 6 short stud top and 1 hex top - Two of the Long stud tops are for the Alt bracket - Where does the third long stud top head bolt go?
check this site maybe it will help you
