like a sensor it screws into the back of the block has a 1 wire connector located in the intake manifold .expensive over $130 for a good product
bolt pattern for 1993 toyota celica starter
On a 1993 Toyota Celica GT, the knock sensor is typically located on the engine block, specifically on the side of the engine near the oil filter. It is usually mounted on the lower part of the engine, often around the cylinder head area. To access it, you may need to remove some components depending on your engine configuration. Always consult the vehicle's service manual for specific details related to your engine model.
yes it will.
in the catylitic converter (underneath car...connected to your exhaust
http://discodan.org/gfx/celica/fuses.pdf
In a 1993 Toyota Celica the radio fuse is located in slot 12. The fuse is rated to handle 15 amps.
Where is the O2 sensor on 1993 Toyota Mr2
Under the intake manifold, right in the middle of the valley, on the block. The intake manifold has to be removed.
THERE IS NO FUEL CUT OFF SWITCH ON YOUR CELICA
no
The thermostat on a 1993 Toyota Celica can be found by following the outlet radiator hose. The thermostat on these cars are located at the bottom of the radiator.
knock sensor