in the catylitic converter (underneath car...connected to your exhaust
The knock sensor for the 1993 Chevy Cavalier is located in the back of the motor. It can also be located in the engine valve.
1993 Honda Civic EX's dont have knock sensors.
like a sensor it screws into the back of the block has a 1 wire connector located in the intake manifold .expensive over $130 for a good product
Where is the O2 sensor on 1993 Toyota Mr2
Under the intake manifold, right in the middle of the valley, on the block. The intake manifold has to be removed.
on top of the engine under the air box
knock sensor
Its located up and alittle to the right of coil packs on back side of block
On a 1993 Toyota Celica GT, the knock sensor is typically located on the engine block, specifically on the side of the engine near the oil filter. It is usually mounted on the lower part of the engine, often around the cylinder head area. To access it, you may need to remove some components depending on your engine configuration. Always consult the vehicle's service manual for specific details related to your engine model.
On top of transmission, drivers side.
If the engine is 3.8L SFI OHV the Knock sensor is located under hood, passenger side, front engine area, below exhaust manifold, mounted in engine block
knock sensor