0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is a rotor hub?
Rotor hub links the blades to the low-speed shaft
What if your xk8 has a clunking noise from the drive shaft at low speed?
There is something serious wrong, please have it checked by a knowledgeable person.
How does an engine works and the function of a gearbox?
An engine is a device that converts chemical energy in the fuel to mechanical and heat energy. This mechanical energy is used to drive a crank shaft which is used to power the wheels of an automobile. The crack shaft is connected to a gear-box which changes the speed and torque of the drive shaft. A lower gear (low speed and high torque) is used for acceleration from halt and a higher gear (high speed and low torque) is used for cruising.
What is diagnostic code 07020 in a jeep grand Cherokee?
P0720 - Low Output SPD Sensor RPM Above 15 MPHThe relationship between the Output Shaft Speed Sensor and vehicle speed is not within acceptable limits. P0720 - Low Output SPD Sensor RPM Above 15 MPHOutput shaft speed is less than 60 rpm with vehicle speed above 15 mph (4-speed auto. trans. only).
Speed ratio between cam shaft and crank shaft?
Cam spins at half the speed of the engine.
Which device controls the speed of the turbine shaft?
The device which control the speed of Turbine is Governor. The Governing system sense the speed of shaft & regulate the Fuel/ Motive fluid flow to the Turbine to maintain the set shaft speed.
What is the purpose of the speed sensor?
It reads the speed of the output shaft.
What causes a creaking from the steering wheel at low speed?
You might possibly have a bent drive shaft, or if you have oversized tires they could be rubbing against the wheel wells
What is the purpose of an output speed sensor?
It reads the speed of the output shaft.
Where is the Turbine Shaft Speed Sensor located on a 1998 Explorer?
The turbine shaft speed (TSS) sensor is located inside the automatic transmission.
How do I replace the output shaft speed sensor on my 2001 Kia Optima?
where is the output shaft speed sensor located on a 2001 Kia Optima?
Can a regular flex shaft cause a slice?
Yes because depending on your swing speed the shaft can be too flexed at impact which causes the face and shaft of ur driver to be open. A faster swing speed needs an x stiff shaft
