It is the primary measurement device for the fuel control computer in your car to know if the fuel-air mixture is too rich or too lean. The O2 sensor is active anytime it is hot enough, but the computer only uses this information in the closed loop mode. Closed loop is the operating mode where all engine control sensors including the oxygen sensor are used to get the optimum fuel economy, with lowest emissions and good power.
A 1969 car would not have an oxygen sensor.
where is an oxygen sensor in 2000 mitsubishi pajero io
A faulty oxygen sensor can make a car smell like gas. Oxygen and gasoline mixing wrong can cause excessive pollution. Replacing the oxygen sensor can correct this issue, and improve the gas mileage in the car.
A malfunctioning oxygen sensor can cause the engine to be low on power.
An oxygen sensor is a device that measures the oxygen in a car's exhaust. The computer uses this to adjust the amount and timing of fuel injected.
If the oxygen sensor fits the catalytic coverter and female vehicle port yes
The function of the oxygen sensor in a Subaru or any other car is to measure the amount of oxygen that is mixed with exhaust gases.
Yes it does cut your car off, The sensor is controlled by module that controls everything
in the car
Yes
When you have a bad oxygen sensor your car may consume a lot of gas. Your car may also drive slower.
The oxygen sensor is located on your lower exaust pipe just before the cat underneath the car