According to the Owners Manual (See "Related Questions" below), that indicates the gas tank cap needs to be checked - likely not tightened enough.
Check fuel cap
Momentarily illuminates when the ignition is turned to the ON position to ensure your bulb is working.
When this light turns on, check the fuel filler cap. Continuing to operate the vehicle with the check fuel cap light on, can activate the Service Engine Soon/Check Engine warning light. When the fuel filler cap is properly re-installed, the light(s) will turn off after a period of normal driving. This period will vary depending on driving conditions.
It may take a long period of time for the system to detect an improperly installed fuel filler cap.
For more information, refer to Fuel filler cap in the Maintenance and
care chapter.
This icon will illuminate if the fuel filler cap is not installed or properly seated.
Check fuel cap: Illuminates when the fuel cap may not be properly installed. Continued driving with this light on may cause the Service engine soon warning light to come on.
On the bottom.
remove speedo from dash turn over you will see timing belt wrote across two holes with a screw in one of the holes.take out the screw and put it in the empty hole this resets timing light on the dash
I have a 2009 murano and that light came on ....its the tire light ...it means the tire needs repair....mine had a screw in it!!
one has a looks like a screw the other looks like a plane
There is not a low idle screw. The computer sends a signal to the idle air control motor and it does the adjusting accordingly. If your idle is to high and your check engine light is on then you need to go to a repair shop and have them diagnosis the problem.
The bottom of a light bulb is a screw.
There is a plastic pen that looks like a screw that must be pulled out beside the light. Then the entire assy. hinges down
On the dash the indicator light looks like a square box that looks like a radiator with a wavy line that looks like water and has an arrow pointing down telling you the radiator water is down. If the coolant reservoir is full, the float is stuck. Simply remove the 10mm screw that holds it down, lift it up with hoses attached and shake it until the light goes off. OR, you can check the float by getting a small wire, unplugging the float wire harness from the coolant reservoir and putting both ends of the little wire in the wire harness plug. If the light goes out... shake the coolant reservoir...it is stuck.
A light bulb is a simple machine. A light bulb is a screw.A screw is a simple machine.
The idle speed is controlled by the computer ( PCM , Powertrain Control Module )