0
What effect will the command spanning-tree link-type point-to-point have on a rapid spanning tree port?
Wiki User
∙ 13y ago
The port will rapidly transition to forwarding.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Which spanning-tree command setting could be assigned to force a catalyst switch to become and remain the root bridge?
root primary
What is the spanning-tree network diameter on a cisco switch?
The default value for network diameter on a STP configuration is 7 (seven). This value can be changed, using the command: Switch(config)#spanning-tree vlan 1 root primary diameter 5 This command changes the network diameter 50 5 (five) hops from end to end
Which two items are true regarding the spanning-tree portfast command?
4. Set the switch priority to a smaller value than that of the other switches in the network.
Which three effects does the interface command switchport host have when entered on a switch?
1.Sets the switchport mode to access 2.enable spanning tree portfast 3.disable channel grouping
When the show spanning-tree vlan 33 command is issued on a switch three ports are shown in the forwarding state In which two port roles could these interfaces function while in the forwarding state?
designated and root
Which spanning-tree command setting could be assigned to force one of the Catalyst switches to become and remain the root bridge?
A Root Bridge is considered better if the Root Bridge ID value is lower than another
What is divine command?
divine command is command given by God
What is the key command for DOS?
Go to the Command prompt and run "help" command to see the command list..
What Windows command prompt command does the same thing as the cat command in Unix?
The 'type' command does approximately (but not exactly) the same thing as the 'cat' command.
What is the command to print directly from command prompt to notepad?
Command+p
What command erases files or groups of files?
The Del or Erase command in command prompt.
Which command is used to clear the command window of Matlab?
The "clc" command is used to clear the command window in Matlab.
