0
The RX8 takes standard anti-freeze.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the location of engine coolant sensor on 2004 Mazda RX8?
It is in the coolant expansion tank Problems with this sensor are common as they are pourous and take up coolant, eventually sinking and bringing on the coolant check light. You most likely will need to change the coolant expansion tank to cure the problem as it is usually sold as a unit. Kev
Need to drain the engine coolant where are the engine plugs on a 1990 ford Ranger?
You drain coolant from the radiator. but according to the book ther are two plugs on the engine block that need to drain the coolant from.
You have replaced the thermostat in a 1994 Mazda B3000 and the engine temp gauge still runs to the hot side Do you need to bleed air out of the coolant line?
flush the radiator
Does a Mazda 3 need antifreeze?
Yes. All internal combustion engines need coolant.
How much coolant do you need to put in your car?
The bigger your car, the more coolant you need to put in. The bigger your engine and car, the more coolant you need
How much coolant does a 1990 Mazda miata need?
Just over six quarts.
What type of coolant does a kx85 need?
A KX85 just needs regular green premixed engine coolant. To replace the coolant in the engine system, simply drain the current coolant and refill. There is no need to flush the system before replacing.
What type of coolant should be used on a 1997 Mazda protege if the car is blowing out cold air?
if car is blowing cold air, you need to check the thermostat,the heater core, and the heat control. the coolant will not blow cold air unless there is no coolant at all in engine,then you have bigger problem anyway
Need a 2004 Mazda B4000 Truck Fx2 Owner's Manual?
www.promanuals.com/serviceparts/2004-mazda-b4000-truck-owners-manual-automated-download
Where is the starter on a 2004 Mazda 3?
I'm in the middle of replacing the starter on my 2004 mazda 3 hatchback. The starter is on the front of the engine. You need to remove the plastic covering from underneath the engine and look between the radiator and the front of the engine from below. You will see it. Hope this helps. It took me a while to find it. The top bolt is time consuming. You might be better off paying the labor for this one. I'm wishing I did.
What brand spark plug do you need for my 2004 Mazda tribute?
original
Why would a Mazda 626 blow cold air through the heater even after the engine is heated up?
Possibly low coolant level or blown heater core.....also check thermostat CHECK COOLANT LEVEL FIRST. IF FULL THEN MOST LIKLY YOU NEED A THERMOSTAT.
