0
Add your answer:
Earn +20 pts
What was the original color of the engine block of the 1949 Mercury coupe?
The original color of the engine block of the 1949 Mercury coupe was typically black.
Where is the VIN on a 1949 mercury?
On the vin plate thatisaffixed to the engine compartment on thefirewall near the passenger side hood hinge. 1949 Mercury 2 door vin starts with 9CM------
What will happen if the thermostat is installed backwards in your 99 Mercury Sable?
The thermostat will not open properly when installed backwards. The coolant will not flow and the engine could overheat.
What does a Mercury switch do on a 650 Mercury outboard?
The mercury switch installed on your engine is designed to short out the ignition to ground when the engine is tilted out of the water. The intended purpose is as a safety feature in the event of striking an under water obstruction during operation.
Where is the block heater in a 1993 Mercury Topaz?
If you have one installed, on the 2.3 L engine, it would be in the back of the engine, looking at the engine from the front of the car. Its in the frost plug.
Why are you not getting fuel to the engine in a 2000 mercury mystique?
try checking the fuel filter, it may have been installed backwards.
Can a new oil pump blow the engine in a 1999 mercury mountaineer?
No. The damaged may have occured before the new pump was installed.
When was Mercury Blues created?
Mercury Blues was created in 1949.
What was the scorpions car called in grease?
1949 mercury
How do you install throttle cable and shift cable on your 1984 40 hp mercury outboard?
The throttle cable and shift cable on a 1984 40 HP Mercury outboard engine is installed by raising the access panel and locating the appropriate connectors. Each cable is then attached to the engine to control its speed and gearing.
Where was the first automatic streetlight system in the US installed in 1949?
The first automatic streetlight system was installed in New Milford, Connecticut in 1949. The first traffic light was used in 1914 in Cleveland.
Will the wire harness on a standard transmission work with an automatic transmission in a 91 Mercury Capri?
yes it will i just had an automatic engine installed in my manuel car. and used the old harness
