For measuring electrical Current the electrical equipment used is Amphere meter. This equipment tells the current flow in the equipment.
Digital Volt Ohm Meter (DVOM)
The HP of a motor is determined by the manufacturer of the motor. The after market user or engineer then determines what size of HP is needed to operate their type of designed equipment. When the customer buys the equipment needed for their type of manufacturing an electrician is hired to connect the equipment to the electrical system. The electrician then determine the overload protection, wire size and voltage drop on long conductor runs.
Alternating Current "AC" & Direct Current "DC"
the equipment needed for investment casting of gas turbine buckets and blades are i dont know you know
One software I know is Auto-cad, which is needed for electrical Drawing.
To answer this question the voltage is needed.
It is an electrical code rule that is determined by the amount of current that a connected device draws. Depending on the amperage that the equipment will draw determines what the size of the wire needed to handle the fault current. The larger the amperage the larger the ground wire needed.
A space of 30 inches or the width of the electrical equipment is needed, whichever is greater, for electrical equipment.
One of the most essential pieces of equipment needed for overseas travel is an electrical adapter. There is such a variety of electrical systems throughout the world that without an adapter, it will be difficult to satisfy all of your electrical needs.
Electrical commissioning is when a company has a equipment on standby to provide electricity if and when it is needed. During power outages this equipment will allow the company to remain up and running.
single phase supply is needed
Two wires are always needed to supply electrical equipment so that the current has a complete circuit to flow in. One of the wires is earthed at the supply transformer, that one is called the neutral, and the other one is the live.
You need wind mills and electrical cords to move the energy from place to place.
Three feet clearance is needed in front of electrical service equipment.
The requirements to become a pat tester include having a certificate and the equipment to perform the job task as needed. Most also require that you have at least trained for a minimum amount of time.
The following equipment is needed to be ready for a foil fencing competition: Underarm Protector Chest Plate (For Ladies) Body Cords (2) Fencing Jacket Electrical Foil Lame Electrical Foils (2) Fencing knickers (pants) Knee- high socks Shoes Mask
What equipment was needed for this experiment
A voltage, a closed path for the current, a consumer (load). It would also help to have a switch, to let you turn the current on and off.