Hannibal Hamlin was replaced by Andrew Johnson because the National Union Party (Created by Republicans and Northern Democrats and lasted from 1864 to 1868) felt he was a stronger vice president and preferred him.
Republicans were always mostly in the Northern states ever since the Civil war. Also republicans favored a strong central government, hence Abraham Lincoln using the most federal power in history. The democratic party was always mostly in the southern states ever since the civil war because many Democrats supported slavery which was mostly in the South. Up unitl 1976 did democrats start to be mostly in the northern states and republicans in the southern states like it is today. They basically flip flopped demographics and ideas over 150 years. Though the demographics have changed republicans have always had a conservative base. Conservatives lost power in the Democratic party during the 1960s. They struggled to survive during the next few decades, many of them switching to Republicans along the way. Eventually with both Obama's victories unfortunately the conservative democrats are now barely existent, everyone left has now switched party affiliation.
First step of the Mississippi plan was to persuade the 10 to 15 percent of white voters still calling themselves Republicans to switch to the Democrats. Second step was to intimidate black voters because, even with all whites voting Democratic, the party could be defeated by the 55 percent black majority.
Bill Clinton was the 42nd president of the united states. This period was 1993 through to 2001. Apart from 1993 to 1995 which was controlled by the democrats, the republicans controlled the house and senate till 2001.
This is usually caused by a bad seat safety switch.
Switch loops
Brake Lights "Stuck" ONUsually that is caused by the brake light switch becoming "out of adjustment," but sometimes it can be caused by a defective brake light switch.
they lost power due to the switch of religion and war
Check the wiring to the switch they break at the connector to the switch tug on the wires a bit sometimes they break inside the wire covering.Or it could be a multifunction switch( the signal and washer high beem switch)
A hot light switch could be caused by an overloaded circuit, loose connections, or a faulty switch. It is important to address this issue promptly to prevent potential fire hazards.
Brake Lights Do NOT turn offUsually this is caused by the brake light switch being out of proper adjustment [most likely], but it also could be caused by a defective switch [less likely].
A flickering dimmer switch can be caused by incompatible light bulbs, loose wiring connections, or a faulty dimmer switch. It is important to troubleshoot and address the issue promptly to prevent potential electrical hazards.