0
What flue gas is measured to determine the efficiency of a gas furnace?
Wiki User
∙ 7y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the difference between flue gas and stack gas?
There is no difference. They both refer to the product that leaves a furnace post combustion
What is the correct flue classification for a solid fuel boiler when connected to a brick flue?
class 1.
Where is a flue located on fireplace?
the flue is the part of the fireplace that goes from the firebox to the outside of the building.
Why doesn't smoke fill the entire house when a fireplace is lit?
The hot air from the fire is less dense than the rest of the air in the house, and is pushed upward into the flue. As the flue fills with hot less-dense gas the pressure difference expelling it increases, and it draws additional hot gasses (smoke) into the flue as the column of gas in the flue rises. When the hot gas exits the flue, its still less dense than the air around it and continues to rise away from the house.
What is in situ flue gas analyzers?
in situ refers that has not been moved from its original place of deposition. this type of flue gas analyzer fixed in stack.
How can you tell if its a high efficiency furnace?
pvc flue pipe and has a condensate drain
Can you run gas furnace and gas hot water heater into one flue?
Of course If the flue is sized properly
What the purpose of the vent on a gas furnace?
The purpose of the vent on the furnace is to ventilate flue gases out side of the house.
What is the purpose of the vent on a gas furnace?
The purpose of the vent on the furnace is to ventilate flue gases out side of the house.
What is the purpose of a vent on a gas furnace?
The purpose of the vent on the furnace is to ventilate flue gases out side of the house.
What is the typical flue gas temperature of a category 3 furnace?
120
What is the Heat loss in blast furnace?
In a furnace large amount of the heat supplied is wasted in the form of exhaust or flue gases.. that s called as heat loss in a furnace..
What is important about measuring the percentage of O2 in the flue gas from fired equipment?
The percent O2 in the flue gas is a measure of the combustion efficiency of the burner. The burner requires excess air to complete the combustion process. This amount of excess air is measured by measuring the O2 in the flue gas and plugging the results into the formula: [O2 / (20.9 - O2)] x 100 to determine the amount of excess air. 0% excess air is 100% combustion efficiency.
What is a furnace draft?
The air flow up your chimney that carries the products of combustion (flue gases) out of your house.
Can a gas fireplace and a furnace share a chimney?
If both fireplace and furnace are BOTH gas, if the flue has the correct size, AND if your building code permits, yes. If furnace and fireplace are different fuels, no. Check with your local building inspection department.
How do you light a pilot for a HVAC?
if it's a 90 % furnace you may have a flue or intake air problem or a bad pressure switch make sure you are venting the flue gases and the fresh air intake is clear
What is the difference between flue gas and stack gas?
There is no difference. They both refer to the product that leaves a furnace post combustion
