Go buy another. if you put in. A lower rated one it will blow if you out in a higher one it may not blow but the short may then burn the wires causing a fire. Buy another 16a fuse fix the short etc
Draw power to your amp. DIRECTLY from he battery, with an "In-Line Fuse"--- thus eliminating any overload on the head fuse
You have a short.
If a 30 amp blows you have a short somewhere. Depends for which circuit, you will have to track it from the unit back to the fuse.
the amp wont work.Check the power fuse first.If this is ok, there is generally another fuse inside the amp that will need checking
Very likely the starter is bad.
You can replace a higher rating fuse with a lower rating provided it works with the device without constantly blowing. So try the 30 amp fuse in your lawnmower and if it doesn't blow and the mower works okay, you are fine. If it blows you will have to go back to 40.
If you are asking can I put a 10 amp fuse in instead of a 5 amp ,the answer is yes. However do not leave it in there. It is ok in an emergency, if the 10 blows right away , then you will have to find your problem.. Always try to keep the proper size fuses installed. If you are asking can I put a 10 amp fuse in instead of a 5 amp ,the answer is yes. However do not leave it in there. It is ok in an emergency, if the 10 blows right away , then you will have to find your problem.. Always try to keep the proper size fuses installed. If you are asking can I put a 10 amp fuse in instead of a 5 amp ,the answer is yes. However do not leave it in there. It is ok in an emergency, if the 10 blows right away , then you will have to find your problem.. Always try to keep the proper size fuses installed.
A 20 amp fuse should be safe to use.Did someone take it out because it blows fuses?? Mark
The 12 Amp fuse will take a larger current before it blows (or trips) - than a 10 Amp one.
http://honda-tech.com/showthread.php?t=2355702
Probably - replace it and see
Only if you want to blow up the microwave. That will let 20 amps go through before the fuse blows when the manufacture is telling you 18 amps max. <<>> Yes, you can use the 20 amp fuse. At 250 volts 2 amps is no problem and you are not going to blow up the microwave. On a fault current the 20 amp fuse will trip just as fast as an 18 amp fuse.