Forget the fuse. Maintain your engine.
Well, that light isn't directly controlled by a fuse - it's controlled through the engine ECM. To pull a fuse for the sake of disabling that light, you'd have to pull the ECM relay.. the problem is, you'd disable the ECM, in turn, disabling the car.
I just had a car inspected with a check engine light on--inspector said it did not matter in Texas.
To reset the check engine light on a 1994 Honda Civic locate the fuse box in the engine compartment. Find the ECU fuse and pull it off for at least 5 seconds. This will erase all codes on the ECU.
eassy pull the fuse box cover off turn it over located the tail light fuse pull it out replace with same amp fuse
you can pull the fuse
pull the ECM/PCM fuse for a few seonds then replace it. that should reset it
Locate the main engine fuse box on the 1999 GMC Savanna van. In the fuse box look for the fuse marked ECU. Pull this fuse out wait 5 seconds and reinsert is. This will reset all codes on the computer.
Check engine lights will not turn off in a vehicle until they are reset. To reset the light on a 1994 Toyota Tercel pull the ECU fuse.
You can disconnect battery or pull the ECU fuse which is in the fusebox. The fuse will say either ECU or EFI (elec fuel injection) Pull the fuse and let it sit about 2 minutes, this will cause a reset, then plug the fuse back in or reconnect battery and that should do it. I got sick of the Check Engine Light so I pulled the instrument cluster, disabled the light permanently, and re-installed the cluster. I hate to spend money for maintaining emission controls since they don't test in Kansas. If I sell the car, I will just re-install the bulb for the engine light
this is an easy question.all you have to do is think basic eletrical box.if a circuit trips in your eletrical box ,you rest the breaker , its the same priincible on a car . all you have to do is start you car ,2nd go to the fuse box and pull the engine fuse out .3rd the running car will die.stick fuse back in and restart the car .your check engine light will go out . dahes
pull the 7.5 fuse out in box under bonnet for 10 secs, you will loose all radio settings
Pull the ABS fuse located in the under hood fuse box. Pull the ABS fuse located in the under hood fuse box.