0
What fuse would you replace for the tail lights in a 2000 dodge durango?
Wiki User
∙ 2014-10-06 23:00:49
The fuses on the 2000 Dodge Durango should be labeled for each part such as the tail lights. The tail light fuse is a 30 A.
Wiki User
∙ 2014-10-06 23:00:49
Add your answer:
Earn +20 pts
How long would it take to replace a steering pump in a Dodge Durango?
In a 2005 Durango, aprox 1 1/2 hours.
What would cause the brake lights to not work on a 2002 Dodge Durango?
Check the fuses and if they are good then check the brake light switch.
What would cause the turn signalhazard not to work on a 2001 Dodge Durango besides the bulbsfuses?
Flasher Relay is defective. Replace it.
How much does it cost to replace a 2003 Dodge Durango water pump?
To replace the water pump on your vehicle if you do it yourself would be about $65. To have a shop do it, it would cost $250 to $300.
How much would it cost at a dodge dealership to replace a fuel pump on a 2003 dodge durango?
I recently had the fuel pump replaced in my Dodge Ram 1500 ... same process. $500.00
Would a Toyota tundra 2001 rims fit on a Dodge Durango 2000?
Would a Toyota tundra 2003 rims fit on a 2001 dodge durango
Does a water pump have a dipstick on a Dodge Durango?
No. There would be no point.
What is the standard amount of time to replace the key cylinder in the steering column on a 2000 Dodge Durango?
about 90 to 100 thousand miles would be accurate
How much would it cost to replace a blown head gasket on a Dodge Durango?
It depends who does it and what exactly is damaged. $1000-3000 depending on how much engine damage their is.
Can a Dodge Durango run without the thermostat?
It would, but it is not a good idea.
Why would a 2000 Dodge Durango transmission slip in reverse?
There can be several things that will cause your 2000 Dodge Durango transmission to slip into reverse. A malfunctioning slave valve can cause this to happen.
Dodge Durango and it will stop running and start again?
when my 1998 Dodge Durango would start and cut back off, I had to reset the alarm by using the lock / unlock buttons on my key remote.
