0
What else can I help you with?
What could you observe when magnesium reacts with sulfuric acid?
When magnesium reacts with sulfuric acid, you would observe the production of hydrogen gas bubbles, the magnesium metal dissolving or reacting to form magnesium sulfate, and the solution becoming warmer due to the exothermic nature of the reaction.
Why does Sulfuric acid have to be warm to be used as a catalyst for ethanol ethanoate reaction?
Sulfuric acid needs to be warm to act as a catalyst for the reaction as it increases the rate of reaction by providing the necessary activation energy for the reaction to occur. The higher temperature helps break the bonds in the reactants, allowing them to react more easily.
What would have happened if sulfuric acid was not add in spectrophotometric titration?
If sulfuric acid were not added in a spectrophotometric titration, the pH of the solution would not be acidic enough to ensure the proper ionization of the analyte. This could result in inaccurate readings or the formation of unwanted precipitates that could interfere with the analysis. Sulfuric acid also helps to stabilize the color of the indicator used in the titration.
What is the purpose of adding a small amount of concentrated sulfuric acid into reaction mixturewhy?
In this reaction, sulfuric acid works as a catalyst, thus if it was removed, the reaction wouldn't occur as quickly, if at all. H2SO4 speeds up the reaction to make it occur more quickly and efficiently.
What 2 names could be given for the following type of reaction Sulfuric acid plus lithium hydroxide equals lithium sulfate plus water?
Neutralization and double displacement
What change could happen during a chemical reaction?
the chemical shall be changed
Would the pH of the solution be lower before or after the enzymatic reaction?
The pH of the solution could change during an enzymatic reaction. It could either increase or decrease depending on the specific reaction and the components involved.
Why is it to get the right blood type during a transfusion?
A reaction to the wrong type could be fatal.
How could a chemist find out how much mass is given off as gas during a chemical change?
How could a chemist find out how much mass is given off as gas during a chemical reaction
What would happen when sulphuric acid is not added in spectrophotometric titration?
If sulfuric acid is not added in spectrophotometric titration, the acidic conditions required for the reaction between the analyte and the titrant may not be met. This could lead to inaccurate results or incomplete reaction, affecting the precision and reliability of the titration. Additionally, the absence of sulfuric acid may alter the chemistry of the system and prevent the formation of the colored complex that is usually measured in spectrophotometric titrations.
Why did the sulfuric acid not clear the drain?
The sulfuric acid did not clear the drain because it may not have been strong enough to break down the clog or there could have been a blockage that the acid could not dissolve.
Is it normal to have a bit of pain during a hair dye patch test?
nope, could be an allergic reaction
