It depends on:
1. technology, whether it's a JFET, enhancement-mode IGFET/MOSFET or depletion-mode IGFET/MOSFET, and
2. polarity, whether it's an N type or P type.
More info needed for this one.
if the gate of MOSFET is fed with negative voltage, the transistor wont attain its saturation state. and it will be in OFF state
If negative voltage is applied to the gate of a NMOS, it repels electrons from the channel region towards the bulk of the p-substrate and attaract holes from p-substrate towards the channel. The recombination between holes and electrons causes a deplation of majority carriers in the channel. Enough nagative gate voltage can cause the channel depleted of majority carriers and cuts off the current between the source and the drain. The least negative gate voltage causing this is called gate-source cut off voltage.
They blow up.
A: It is not a bypass it is a negative feedback to effect the input voltage, Bias is when a DC voltage is applied to insure proper operation
Negative voltage is voltage that is more negative in polarity than the ground of the circuit.AnswerSince 'voltage' is simply another word for 'potential difference', it can be neither negative or positive in the 'charge' sense! These terms can only be applied to 'potential', not to 'potential difference' (voltage).So, the terms 'positive' and 'negative', when applied to voltage, simply indicate sense or direction in which the potential difference is acting. For example, if you decide that a car battery's voltage is acting in the 'positive' sense in the charging circuit, then the alternator's voltage must then be acting in the 'negative' sense -in other words in the opposite direction to the battery.
The voltage is greater than the applied voltage, why?
punchthru, resulting in destruction of the FET
If negative voltage is applied to the gate of a NMOS, it repels electrons from the channel region towards the bulk of the p-substrate and attaract holes from p-substrate towards the channel. The recombination between holes and electrons causes a deplation of majority carriers in the channel. Enough nagative gate voltage can cause the channel depleted of majority carriers and cuts off the current between the source and the drain. The least negative gate voltage causing this is called gate-source cut off voltage.
When an alternating voltage is applied to a purely resistive circuit, the resulting current is in phase with the voltage.
They blow up.
no
An air conditioner clutch will not engage without voltage. If it doesn't engage, the compressor will not turn.
A: It is not a bypass it is a negative feedback to effect the input voltage, Bias is when a DC voltage is applied to insure proper operation
It turns off. Once the SCR is turned on (fired) it stays on until the voltage across it goes to zero. One way to do that is to hit it with a negative pulse. You need to be careful about how large that negative pulse is, though, as you could destroy the SCR.
Any voltage that is fed into or "applied" to an electrical circuit is referred to as an "applied voltage".
Negative voltage is voltage that is more negative in polarity than the ground of the circuit.AnswerSince 'voltage' is simply another word for 'potential difference', it can be neither negative or positive in the 'charge' sense! These terms can only be applied to 'potential', not to 'potential difference' (voltage).So, the terms 'positive' and 'negative', when applied to voltage, simply indicate sense or direction in which the potential difference is acting. For example, if you decide that a car battery's voltage is acting in the 'positive' sense in the charging circuit, then the alternator's voltage must then be acting in the 'negative' sense -in other words in the opposite direction to the battery.
Resistance calculations are the same no matter what the polarity of applied voltage. R=E/I Resistance (in ohms) = Voltage (in volts) divided by Current (in amperes)
At pinch off voltage, the channel is blocked at its maximum. (depletion region blocks almost entire channel, so no charge exchange). Therefore, no drain is flown through the channel.