0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
what od bolts does it use?
The rod bolts that you use for this product are ACC 215 Rod bolts.
How do you tighten up tie rod on a 2003 Chevy?
You can not tighten a T-Rod end up. If it is loose then replace it.
How to change fuel pump on 77 Chevy blazer?
Remove fuel lines, remove two bolts that hold fuel pump, if V/8 you may have to remove inspection plate to insert the push rod back up into the block. The plate has two bolts that hold it on. Remove with 7/16 wrench or socket. use some type of grease to hold the rod in the block. if the rod drops the fuel pump will not go back on. Tighten to bolts for the pump to 27 ft lbs and the plate bolts to 22 inch pounds. Reinstall fuel lines, tighten to 22 ft lbs.
What is the torque for a 1.9 Saturn engine piston rod?
I believe these are torque to yield bolts and the specs are: Initial torque to 19 Ft/Lbs Tighten an additional 75 degrees It's also not a good idea to reuse these bolts as they are stretched when tightened.
tie rod end bolts on 2003 honda civic?
tie rod end bolts on 2003 honda civic
What are the connecting rod torque specs for a 2000 Saturn with a 1.9 dohc?
I believe these are torque to yield bolts and the specs are: Initial torque to 19 Ft/Lbs Tighten an additional 75 degrees It's also not a good idea to reuse these bolts as they are stretched when tightened.
What are the parts of a water tank?
Fill valve, Douglas valve , Over flow tube, handle , stopper , flapper , float, lift rod , guide rod tank bolts, disc
How tight to tighten nuts on rod?
15 to 30 ft lbs
What is torque specs for main and rod bearing 1996 geo prizm?
The service manual says: Main bearing cap bolts 60N-m (44 ft-lbs) Connecting rob bearing cap bolts 29N-m (22 ft-lbs) then tighten an additional 90 degrees.
What happens if one iron rod is rubbed with another iron rod?
what change will take place if two same materials are rubbed over each other
What is the torque on Rod Bolts on a 2001 4.7 dodge?
Warning! These are "torque to yield" bolts. Once installed and torqued to spec they yield, or stretch. The bolts, once loosened, cannot be reused. They MUST be replaced with new or they WILL fail. Once you have new bolts, the tightening sequence is 20 ft/lbs, then tighten an additional 90 degrees (exactly one quarter turn).
What is the rocker arm torque specs and sequence for a Chevy 305?
With the valve fully closed and the lifter fully at the down position, tighten the adjusting nut until there is no up and down travel in the push rod. Then tighten the adjusting nut 1/4 turn. This is only if you have hydraulic lifters. Tighten the rocker studs to 50 ft/lb of torque. These are the bolts holding the rocker assembly in place.
