answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What happens to light as it travels through fog?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What happens when your headlights shine into fog?

the light doesnt go through the fog


What happens when you shine a light through a fog what is this called and why does it happen?

The fog is called a colloidal solution. When light is shined through this colloidal solution, the light scatters in all direction because of the substance contained in this solution type.


Light happens to rain droplets falling into a layer of fog Do they increase or decrease in size and what happens to the fog?

jgtgtgtgtgtgtgtgtgtgtgtgtgtgtgtgtggggggggggggggggrtrrrrrrrrrrrrrriiiiiiiiiiiithjjjjjjjjjjjjidfffurrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrre


How do you replace a fog light bulb in a 2005 Subaru?

You will have to access the fog light bulb from below the vehicle. Remove the plastic clips from the wheel well cover extension that is below the fog light. Once the clips are out and the plastic cover is pull down, you should be able to see the back of the fog light. You can try to replace the fog light bulb now or remove the two 10mm bolts and slide the fog light assemble out through the front of the bumper. Turn the cover of the rear of the fog light and replace light.


What are fog lights on a car?

fog lights are located on the bottom of the front bumper and help the driver see when driviing through fog. cause the light passes under the fog rather than through it. so you can see the road.


When does the fog light sensor 98 dodge ram 4x4 1500 activate?

There is no "fog light sensor".There is no "fog light sensor".


How do you change fog lights on 2004 dodge SX 2.0?

Remove the fog light retaining bolt. Remove the fog light wiring harness. The fog light will come out. Reverse the process to install the new fog light.


Why do you see the beam of a torch if it is foggy?

Fog is water vapor in the air. When light hits fog, some of that light bounces off the tiny specks of water and reaches your eyes causing the vapor to look illuminated. the rest of the light travels through the water to illuminate the rest of the vapor in its path. This also works using any other light source, with any other partially vaporized liquids, or even solids suspended in the air, ie smokes and powders. For a really fun time, invite a few friends over, give them all laser pointers, and fill the house with artificial fog using a fog machine.


Installing fog light in 2000 trans am?

To install fog light in a 2000 Trans Am, disconnect the fog light switch from the housing. Then remove the washer, bolt, and nut. Finally, remove the fog light housing, twist the fog light off, and replace. ?æ?æ


Why do lasers appear in smoke or water?

In order to be seen, light must reach the eye. Since laser light is coherent, it travels only along its line of propogation, so there is no light to be viewed from the side of the beam. However, when a laser beam passes through fog, it is reflected off of tiny particulate droplets of water in the fog (or smoke particles in smoke), so is diffused in all directions and can be observed. In order to be seen passing through water, there must be suspended particles in the water from which the light can be reflected. The beam should not be visible as it passes through perfectly pure water.


When was Fog Point Light created?

Fog Point Light was created in 1827.


How do I Remove the fog light on a rav4?

how do i remove rear fog light on rav4