The flame itself will get bigger/hotter, and the amount of 'blue' increases. Depending on the type of burner, it may or may not increase proportionately with the total flame size.
the 'roaring' flame - which is the one when the oxygen valve is open.
The most stable flame is a blue flame (produced when air valve is open)
it turns into a blue flame by changing the air valve on a Bunsen burner.
Increase the air flow by opening the circular valve on the stem of the burner. This will cause the flame to burn more intensely and with a blue flame. When the valve is closed, the flame will burn yellow and cooler - more like a wax candle's flame.
You can make the flame hotter by first, lowering the flame from the starting point by slowly closing the gas valve until the flame is at a medium height. Then, you should increase the oxygen intake by slowly opening the oxygen valve until you have a completely non-luminous flame (an all-blue flame), which is hotter than an orange or yellow flame.
adjusts the size
yellow when fully open if on a bunson burner
If you open the valve on the bunsen burner fully the flame becomes virtually invisible and therefore there are no interactions between the original flame colour and the colour produced by the chemical.
the 'roaring' flame - which is the one when the oxygen valve is open.
A Bunsen burner flame can both roar and burn quietly, by allowing more oxygen to reach the flame by opening a valve it will roar, by closing the valve the flame will flicker
The most stable flame is a blue flame (produced when air valve is open)
it turns into a blue flame by changing the air valve on a Bunsen burner.
Increase the air flow by opening the circular valve on the stem of the burner. This will cause the flame to burn more intensely and with a blue flame. When the valve is closed, the flame will burn yellow and cooler - more like a wax candle's flame.
You can make the flame hotter by first, lowering the flame from the starting point by slowly closing the gas valve until the flame is at a medium height. Then, you should increase the oxygen intake by slowly opening the oxygen valve until you have a completely non-luminous flame (an all-blue flame), which is hotter than an orange or yellow flame.
The needle valve or flow valve controls the flow of gas into the Bunsen Burner.
The needle valve or flow valve controls the flow of gas into the Bunsen Burner.
A Bunsen burner flame is hottest when the air valve hole is open.