0
What happens when NC and NO contacts not work in electrical panel?
Wiki User
∙ 14y ago
When a NC and NO contacts are not working the NC will not open and the NO will not close.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why does your Saturn SL2 dome light only work if you smack it multiple times?
It could be corroded bulb contacts, switch contacts or other electrical connection. Clean the contacts and coat them with electrical contact grease to prevent future corrosion. OR it could also be just a defective bulb. Same thing happens on light bulbs in my home AND headlights on my car.
Can you install electrical panel in closet?
No, there has to be a three foot clearance in front of the panel. This is so that electricians can work safely on the panel.
Miller big 40 welder does not work?
USE ELECTRICAL CONTACT CLEANER FOR ALL CONNECTIONS AND FINE EMERY CLOTH ON CONTACTS USE ELECTRICAL CONTACT CLEANER FOR ALL CONNECTIONS AND FINE EMERY CLOTH ON CONTACTS
What is it when you put your car into drive the instrument cluster panel wont work?
electrical issue
What brand of electrical panel box is compatible with Gould brand breakers?
Siemens bought Gould so a Siemens panel should work.
Should the electrical sheathing project more than one inch into the electric panel?
No, it shouldn't. Electrical work revolves around recommended and non recommended procedures. In this case, the sheathing needs to project no more than about one inch into the electrical panel.
What is a LT panel?
An LT panel, or Low Tension panel, is an electrical distribution panel that receives power from a transformer and distributes it to various electrical loads at a lower voltage, typically below 1000 Volts. LT panels are commonly used in industrial, commercial, and residential buildings to control and protect electrical circuits.
What causes electrical work?
It happens after someone asks for it to be done for some reason.
How do electric irons work?
Irons are rather simple in how they work. They work like an electric heater. They have a heating element made out of a metal alloy that gets hot when electricity is applied. Wired in series with the heating element is a thermostat. The thermostat is made of two electrical contacts that are designed to bend away from each other as the iron gets hot. The knob turns a screw which control how hard the contacts must bend to separate and break the electrical connection. The higher the thermostat is turned, the hotter the iron must get before the electrical contacts separate. Then when the iron starts to cool, the contacts make connection again, thus keeping the iron steadily at the desired temperature.
Will a panel breaker for one manufacturer's panel fit on a different manufacturer's panel?
Yes, some can work in other panels. But you go to an electrical supplier and get the one that is the brand of the panel. If it is old and you can't find it, then try a GE breaker.
Can you install 200 amp service Panel in washer Dryer closet?
No, you can not install a service panel in a washer/dryer closet. The National Electrical Code (US) requires you to maintain work space in front of the panel (3' deep and 30" wide)
Can a 3ph 208V 42 circut electrical panel that is recessed in the wall have a wood trim and a cabinet style door installed in addition to the panel cover door?
Yes as long as the removal of the distribution panel cover is not impeded by the cabinet door. The distribution panel cover must be able to be removed for an electrician to be able to work on the panel.
