USE ELECTRICAL CONTACT CLEANER FOR ALL CONNECTIONS AND FINE EMERY CLOTH ON CONTACTS USE ELECTRICAL CONTACT CLEANER FOR ALL CONNECTIONS AND FINE EMERY CLOTH ON CONTACTS
40 holes per inch.
40 hours a week
The world's largest glacier is the Lambert Glacier. It is 320 miles long and 40 miles wide.
hi . my question is ? why if run the motor car he not work the automatic choke after 5 minte he work , & after 40 minte if the rang the heat up inthe car hew is stop
$60.10 based on a year having 2080 work hours. (52 weeks at 40 hours per week) However, most people at that salary level work much more than 40 hours per week.
Look for a welding supply shop or contact a welder and he can tell you his supplier.
Depends on what time your employer wants you to be at work.
Approximately 50% of welders work 40-50 hours a week but some can push up to 60. Thats a lot of money$$$
10,000 Watts
the average pay for a welder is bewteen $40 and $80 an hour
40-56 hourly
No, it is not safe to plug a 120v 20 amp welder into a 240v 40 amp outlet. The voltage difference is too high and could damage the welder. It is important to match the voltage and amperage of the welder with the corresponding outlet.
You can find a Miller Big 40 faceplate at various welding supply stores, both online and in physical locations. Websites like Amazon, eBay, and specific welding equipment retailers often stock this item. Additionally, you may check Miller's official website or authorized distributors for availability. If you're looking for a used option, local classifieds or welding forums might also be helpful.
No, the wire will overheat.
Glenn Miller died on December 15, 1944 at the age of 40.
they moved their location somewhere and the welder is quite valuable i believe.
The size of the circuit breaker and the wire that will feed the welder is based on the amperage that is needed by the welder. The voltage only explains what the insulation factor of the wire should be.As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.