0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why would my Tahoe try to start when you connect the battery WITHOUT a key in the ignition?
Did you just put a starter on it ??? Sounds like the starter wires are on the starter wrong are thay are shorted out. CHECK THE WIRES GOING TO THE STARTER CLOSELY.
Why makes the starter on 1998 silverado engage when the positive cable is connected and the key is not in the ignition?
Did you put a starter on it ? If so, Then you have put the starter wires in the wrong place are you have the big battery wire touching the small wire that goes to the starter. Recheck the wiring on the starter.
You put a new starter on your 95 jeep it will start if you jump across the starter but not with the key why?
Hooked up wires wrong or ignition switch bad out/ of adjustment
How do you install a starter for a 1988 Chevy 305?
Un-Hook battery- Unhook wires off old starter. (should be 3 wires ) some are 4 If unable to access wires take starter off first and then take off wires, Unbolt starter- will slide forward towards front of vechicle- and replace new starter everything vise-versa-- Don't worry because their is No way to put it in wrong because it will only GO in (1) way.. Note: U may want to mark your wires- so that you know where to place them when you put the new starter in.
How do i replace 97 surburban starter exactly?
Disconnect the positive battery cable and then take out the starter bolts and remove the wires/ then put the wires onto the new starter, put the stater back on and then put the battery cable back on.
What happens IF the wires from a battery charger are put the wrong way round onto battery terminals and left to charge?
charger i had was wired wrong. soon as it was plugged in the charger stopped working. if wires are wrong it just will not charge and can be dangerous!
How do you replace a starter for a 1990 Buick Regal Gran Sport?
There are several wires that must be removed from the existing starter before it can be replaced. The wires need to be taped and labeled so that they can be put correctly back on the new starter. The old starter needs two bolts to be taken out to put the starter in.
I have power to my 76 camino starter but nothing happens when I turn the key. Is is in the wiring between the starter and the key?
the wire on the little peg is on the wrong one ther should be one directly across put it on that one to engage your starter
What happens when you put a tire on wrong?
why/how do you think you put it on wrong?
Is there a certain way to put the wires on a starter?
Yes but it varies from car to car
How do you change a starter motor in a EF falcon?
The easiest way to change them is on a hoist. if you dont have acess to one jack up the front of the car and put stands under it.disconnect the batterythere will be two bolts going through the starter into the bellhousing, remove the two bolts. they should be 13mmonce you remove the starter remove the wires attached to the solenoid making sure to take note of where the wires go.it is easier to remove the wires once the starter is out as you will have more room.when you put the new starter in put the wires on firstfit the starter then reconnect the batteryRead more: http://www.justanswer.com/questions/1woj2-change-starter-motor-ford-falcon#ixzz0TUgd4eNV
How do you change the starter for a 1982 280ZX?
remove wires from the top of starter, remove the two bolts that attach starter to bell housing, pull starter off, reverse to put starter back on
