Un-Hook battery-
Unhook wires off old starter. (should be 3 wires ) some are 4 If unable to access wires take starter off first and then take off wires,
Unbolt starter- will slide forward towards front of vechicle- and replace new starter everything vise-versa-- Don't worry because their is No way to put it in wrong because it will only GO in (1) way.. Note: U may want to mark your wires- so that you know where to place them when you put the new starter in.
The Chevy starter does not have a ground wire, the starter grounds through the starter casing.
intake manifold is DIFFERENT for models 1985 and 1988
yes
yes if they are both throttle body engines
If you have a 305 or 350, it is 1,8,4,3,6,5,7,2.
It is screwed into the passenger side of the engine block just in front of the starter. It will have an electric wire pluged into it.
Could be a bad battery or starter.
Should be the 700R4
No. There were major engine changes between those years.
Set the points for 30 degrees dwell. 1988 305 has electronic ignition.NO POINTS.last year for points was 1974
Disconnect the - battery cable Raise and support vehicle Disconnect wiring at top of starter Remove starter mounting bolts Remove starter
connected to thermostat housing