0
What else can I help you with?
How many BTUs will a 10-kilowatt heater produce if operated for 1 hour?
A 10-kilowatt heater produces 34,120 BTUs per hour.
What is the Gallon Per Hour use of a kerosene heater?
Depends on the BTUs of the heater.
How many btus in a 2000 watt heater?
2000
How many BTUs in a 6 ft baseboard heater?
The number of BTUs in a 6 ft baseboard heater would depend on the model and specifications of the heater. On average, a 6 ft baseboard heater can generate around 1,000-1,500 BTUs per linear foot, so a 6 ft baseboard heater may produce approximately 6,000-9,000 BTUs.
How many BTUs does it take to raise the temperature in a 40 gallon water heater 60 degrees F?
To calculate the BTUs needed to raise the temperature of a 40-gallon water heater by 60 degrees Fahrenheit, you can use the formula: BTUs = gallons × temperature rise × 8.34. For a 40-gallon heater, it would be 40 gallons × 60°F × 8.34 BTU/gallon°F, resulting in approximately 20,016 BTUs. Therefore, it takes about 20,016 BTUs to achieve that temperature increase.
What propane heater has the most BTU's?
The "Mr. Heater F232000 MH9BX Buddy" portable propane heater has one of the highest BTU outputs for a portable heater, at 9,000 BTUs. If you need even more heat output, industrial propane heaters can go up to 400,000 BTUs or more for larger spaces.
What air conditioner has the most BTU's?
With 28,000 BTUs, the Friedrich SL28L30* has the most BTUs.
How long will a 100 pound tank last on a 15000 btu wall heater?
To estimate how long a 100-pound propane tank will last with a 15,000 BTU wall heater, you first need to know that propane contains about 91,500 BTUs per gallon, and there are approximately 37 gallons in a 100-pound tank. This results in about 8.8 million BTUs total. If the heater runs continuously at 15,000 BTUs, the tank would last roughly 8.8 million BTUs ÷ 15,000 BTUs/hour = about 586 hours. However, actual usage may vary based on heating cycles and efficiency.
How many btu per hour would be produced in a 12-kW electrical heater?
There are at least 5 different definitions for slightly different BTUs. One of them says that 1 kWh = 3412.14 BTUs. Let's use that one. 1 kWh = 3412.14 BTUs 12 kWh = 40,945.68 BTUs
How do you determine the Btus in your electric hot water heater?
A BTU is the amount of energy required to raise the temperature of 1 pound of water 1 degree Fahrenheit (F) at or near 39.2 degrees F and 1 atmosphere of pressure. Electric heaters are rated in KW, not BTU's 3413 BTU's = 1 KW-hr. Check the link below for a PDF on water heater sizing.
How many gallons of kerosene will a 400000 BTU forced air heater use?
To determine the gallons of kerosene a 400,000 BTU forced air heater will use, you need to know the energy content of kerosene, which is approximately 135,000 BTUs per gallon. Dividing 400,000 BTUs by 135,000 BTUs per gallon gives you about 2.96 gallons. Therefore, a 400,000 BTU heater would use roughly 3 gallons of kerosene for each hour of operation at full capacity.
How many btu's do you need for outside patio heater?
The required BTUs for an outdoor patio heater typically range from 30,000 to 50,000 BTUs, depending on the size of the area you want to heat. For smaller spaces, a heater with around 30,000 BTUs can be sufficient, while larger areas may require heaters with higher outputs. Additionally, factors like wind exposure and desired temperature can influence the BTU needs. Always check the manufacturer's specifications for optimal performance based on your specific setup.
