Want this question answered?
Hydraulic fluid and hydraulic oil are one in the same.
It uses Hyster Hydraulic Fluid
Brake fluid is a hydraulic fluid with very specific properties. Use exactly what the manufacture specifies for your particular braking system.
All Bobcats use Bobcat Premium Hydraulic/Hydrostatic Fluid.
The Mazda b3000 pickup truck does not have hydraulic fluid. None of the vehicles components use hydraulic fluid in any way.
were do you put the hydraulic fluid in 2000 ford tractor
A hydraulic motor is actuated by the hydraulic fluid which is pumped into it, and will use this fluid energy to turn a shaft or mechanical gearset, thus converting fluid energy into mechanical energy.
For measuring the flow of hydraulic fluid.
Any kind of hydraulic fluid, it is all fundamentally the same.
It depends on the system, sometimes yes.
Use hydraulic jack oil, available pretty much anywhere - I used Johnson's, 1qt bottles are $7.99 at my local O'Reilly. To fill, or replace, the fluid you'll first remove the seat cushion. It should just lift off. Under that there will be a hole in the center of the base, it may or may not be covered by a plastic cap or a screw on older models. Remove the cap to access the fluid reservoir. I would suggest removing as much existing fluid as you can before adding more, to avoid overfilling the pump. You can find a suction gun at harbor freight for about $15 which you can use to remove as much of the fluid in the chair as possible, without having to disassemble the pump mechanism. Place your control lever in the full down position, this will allow clear access to feed in the suction tube, as well as assure the chair is fully "down" and thus the reservoir as full as possible. Once empty, refill with hydraulic jack oil. Add one quart to start, and pump the chair up. If it gurgles while raising and before topping out, or when lowering, lower and add another 2-4oz and repeat the process until it makes no liquid noises when being raised, and doesn't gurgle or gush when being lowered. If you add too much fluid, the seals may be damaged and/or the chair will be very difficult to lower after being raised. Also do not EVER use any oil/fluid which mentions "stop leak".
Hydraulic fluid is hydraulic oil.... as for the type you use, depends on your system. I used to own two tractor-trailer end dumps, and I actually used ATF rather than hydraulic oil. Check with the OEM for your hydraulic system before you do this, though.