u have a slave cylinder bolted on the side of the transmission,check to see if it is leaking,if it is ,replace and bleed,if not leaking .check your clutch master cylinder to see if its low, if not ,then u may need anew clutch.
no,4 cylinder transmission will not work
Yes, you need to get a top loader transmission and linkage
no
yes
Hydraulic brakes can not be adjusted,check your clutch master cylinder and slave cylinder for leaks,the slave cylinder is bolted onto transmission,has arubber cover toward the end,if these are not leaking,then you may need a new clutch kit.
no
The Nissan 4 cylinder will not bolt up to a V6 4x4 transmission. This is because transmissions coupled to four-cylinder engines normally use 21-spline output shafts.
if its hydraulic,u cant,check your slave cylinder for leaks.
Its hydraulic ,you cant,check your slave cylinder to see if its leaking,its located thru a rubber cover on side of transmission,if leaking replace and bleed,also check clutch master cylinder,if not leaking,then you might need a new clutch kit.
Its mounted on transmission.
no,you cant swap a 4 cylinder and a 6 cylinder out,totally different.
From the passenger side,get under truck and look at side front of transmission,theres a hole in transmission with a rubber cover and the slave cylinder is bolted onto it with 2 bolts and the clutch fluid line is attached to the slave cylinder,if bad,then it will be leaking.