0
What if your network is configured as a single IP subnet Multiple hubs are connected to an Ethernet backbone You need to reduce the number of collisions on the network.What should you do?
Wiki User
∙ 14y ago
Install a switch.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What characteristic to an Ethernet network using hubs does using an Ethernet switch minimize or avoid?
Collisions
What are two problems that might cause excessive data collisions on an ethernet network?
Too many computers connected, and trying to transmit at the same time; and the use of switches instead of hubs.
What is the function of CSMA CA on a wireless Ethernet network?
To prevent collisions.
What is the role of the Ethernet port on a PC?
The role of the ethernet port on a PC is to allow internet to be connected. Without an ethernet port, there is no place for the computer to be connected to the internet.
What do you turn on to share a printer with network users?
If your printer is attached directly to your computer, you should share it (the way you do it depends of your operating system). If your printer is connected directly to your network (WiFi or Ethernet) it should be properly configured.
What happens when you plugin the Ethernet cable to your PC?
when ethernet cable is plugged in it is detected by ethernet card. if the cable is connected to network it detects that network and dispalys " you are connected to network"
Why are wireless technologies like WiFi and 3G unable to reuse the Ethernet data link layer?
Wired Ethernet can physically detect collisions, WIFI can't.
How are collisions detected on an Ethernet network?
by comparinig the xmit line to the recieve line and look for differences
What is difference between serial interface and Ethernet interface?
The FastEthernet interface of R1 is disabled. One of the default routes is configured incorrectly. A routing protocol is not configured on both routers. The default gateway has not been configured on both routers.
The bus cable to which computers on the Ethernet is connected?
The bus cable to which computers on the Ethernet is connected is called the trunk. If the trunk breaks, a bus topology is completely disrupted.
Where is a wireless router connected to a computer or modem?
A wireless router will usually be connected directly to a high speed modem between the modem and any other device. This allows the router to correctly pass internet requests from the local network (computers connected wirelessly or to a standard port) to the ISP (the high speed modem connected to the Internet port). Connecting a wireless router to a computer would be unusual but it could function if connected to the network port on the computer provided the router-computer connection was properly configured. In this case the computer would have to be configured to route.
Why does your internet not work when the ethernet cable is plugged into the correct slot of your router but works when connected to one of the open ports?
There are two cases. First one is because your router is configured to use one of open ports for internet connection. Second is your router has to be replaced if the fact bothers you.
