A suspension bridge is supported from a height of 30 feet. The length of the wire used to suspend the bridge, from the ground to the top, is 65 feet. What is the angle of elevation from the base of the bridge to the point of suspension?
The Verrazano-Narrows bridge connects Brooklyn and Staten Island and is named for Giovanni da Verrazzano. The bridge is constructed from concrete pilings, steel wire cables, iron eyebars, steel girders, and steel towers.
The cause of resistance is the opposition to the flow of charges.Resistance occurs due to the collisions between charges inside a substance. The resistivity of a wire can be found out by using a meter bridge or a slide wire bridge.
The Severn Bridge is located close to the former Aust Ferry. The bridge is a suspension bridge of conventional design, with the deck supported by two main cables slung between two steel towers. In 1966 the cables supporting the bridge deck were spun from 18,000 miles (29,000 km) of wire[5]. The bridge is 5,240 ft (1,600 m) long, consisting of a 3,240 ft (988 m) central span between the towers and the two 1,000 ft (305 m) side spans. The towers rise to 445 ft (136 m) above mean high water and are of hollow box construction. The deck is an orthotropic steel box girder of aerofoil shape with cantilevered cycle tracks and footway supported from the box
Wire. conductors. Wire made into a coil, an inductor.
we can measure the resistance of the given wire using the carey foster bridge / ?
A Carey-foster's bridge is a modified version of the meter bridge (wheatstone bridge or potentiometer). It can be used to find out the average resistance per unit length of the meter bridge wire and hence find out the unknown resistance. It is more accurate and more sensitive than a meter bridge.
the principle of wheatstone bridge is,there is a potential fall is directly proportional to the length of the wire, and this fall is also equalt to the fall accross the resistances applied in parallel to the battery. It is a form of wheatstone bridge.
The Brooklyn Bridge is a suspension bridge made from wire cable.
The Brooklyn Bridge is made of wire cable.
Yes. They're called suspension bridges. The Golden Gate Bridge outside San Francisco is one of them. The suspension cables are made out of wire. Very thick wire but wire non the less.
metal concrete wire plastic steel
the golden gate bride is made out of 27 572 strands of wire on each cable
The Brooklyn Bridge was the first suspension bridge to use steel for its cable wire and the first to use pneumatic caissons.
A suspension bridge.
(a) The connection between the resistors in a meter bridge is made of thick copper strips because the resistivity of a copper wire is very low. As, the connections are thick, so the area becomes large and the resistance of the wires becomes almost negligible. (b) It is preferred to obtain the balance point in the middle of the meter bridge wire because it improves the sensitivity of the meter bridge. (c) Constant is used for meter bridge wire because its temperature coefficient of resistance is almost negligible due to which the resistance of the wire does not get affected on increasing temperature of the wire during flow of current.
A jumper wire should use to bridge electrical ground across?