Splice Tape is used to join SMT component reels together which reduces Pick & Place Machine downtime, thus providing time and overall cost efficiencies.
Shenzhen Kanghongjin Electronic Co., Ltd is a leading manufacturer of SMT/SMD and AI (Auto-insertion) accessories and consumables based in Shenzhen, China. Their factory in Longhua Town of Shenzhen City manufacturers quality SMT splice tapes, SMT splice tool, stencil clean roll, cleanroom wiper, Kapton tape and ESD products for PCB assembly industry.
Actually SMT trading market is not very small,varying from whole smt lines,machines,smt feeders to even a screw,companies can sell or buy on every B2B web(alibaba,ecplaza,etc),or professional SMT trading platform(smtnet,etc), And there are many companies have their smt part information posted on internet,it's the direct way to buy or sell smt parts.
No. When you splice a ground it needs to be made by accepted means and the splice must be inspectable. Covering the splice with tape prevents inspection.
God no!!! The tape is shielded for a reason. It will cause a heat build up that can lead to and electrical fire.
Strip the wires back about 3/4" and then using lineman's pliers twist the wires together about 2 turns. Tighten a wire nut securely to the connection. Then tape the splice securely with electrical tape.
Go to a store or search on the internet for "Professional video recording supplies". These stores deal with TV stations that have recording equipment that still use tape systems. They sell a special tape that you can get to splice the tape. You take the ends of the vcr tape and overlap them an inch. Make a diagonal cut across the tape with a very sharp razor or knife. Keeping the tape still together, remove the cut ends. Place the repair tape over the diagonal cut and press in place. Slightly undercut the repair tape edges where the splice occurs so the tape won't be too wide to pass the guides in the tape recorder or player. After this, you need to get a DVD recorder to burn this tape to a DVD for historical archiving and playback. (much better than tape).
yes but it, not advised very dangerous (house fires) ---------------------------------------------------------------------------------------------- ive did it many times, just make sure you use good electrical tape, and tape each splice seperately, then tape the 2 together. you want there to be no chace of the wires touching, so use a fair amount of tape.
you could split two video files into one but not a actual video tape
Cover tape extenders are used when a reel of SMD components doesn't have a leader at the beginning of the reel. The tape extenders add an additional 508mm (20") of tape as a leader and feed into SMT placement equipment as a piece of cover tape. These tape extenders reduce the loss of components when you have no leader tape to work with. Can be used with either paper or plastic tape, punched or formed pockets, from 8-44mm width.
Buy a harness for your vehicle... splice the wires together by color.. wrap them in electrical tape =)
If its the drivers door lock switch not working, 99 times out of 100 the problem is a corroded/broken splice in the wires. The wires/splice run under the passenger side carpet. Remove the passenger side plastic door-sill plate and pull up the carpet revealing the wire harness. Unwrap the electrical tape, find the solid white wire and solid light-blue wire. On the white and blue wire there is a splice(wrapped in electrical tape) with 2 wires splicing into one wire. You will need to remove the electrical tape and most likely you will find the splice is corroded or completely broken(due to water leaking inside-another story). Cut out the corroded wire and splice in a new piece of wire, wrap in electrical tape and you should be good to go.
You can either splice the wires together, then tape it with electrical tape, which will then form a connection again, or you can go buy another one. If it were me, I'd buy a new one.