A tapped inductor is a coil to which electrical access is available at more points
than only the two ends. Connection points are provided at one or more points
on the coil that are between the ends. Each such point is called a 'tap'.
Since we know that inductance of an inductor depends on the length of inductor by the formula L=muAN*N/l, where l is the length of inductor. So by varying the length of inductor we say that inductance of inductor varies.
In an ideal inductor, no, there is no voltage induced across an inductor unless the current in the inductor is changing. However, since there are no ideal inductors nor power supplies, eventually an inductor will draw a constant current, i.e. the limit of the power supply; and, since no inductor has zero ohms at equilibrium, that current will translate to voltage.
A changing current through an inductor induces a voltage into the inductor, the direction of which always opposes the change in that current.So, in a d.c. circuit, an inductor will oppose (not prevent) any rise or fall in current, although the magnitude of that current will be determined by the resistance of that inductor, not by its inductance.In an a.c. circuit, because the current is continuously changing both in magnitude and in direction, it acts to continuously oppose the current due to its inductive reactance. Inductive reactance is proportional to the inductance of the inductor and the frequency of the supply. The vector sum of the inductive reactance of the inductor and the resistance of the inductor, is termed the impedance of the inductor. Inductive reactance, resistance, and impedance are each measured in ohms.
Because inductor forms a coil with magnetic field around it. It acts as a relay also. Tasleem
A resistor or an inductor. The inductor limits transient current, not steady state current.
An oscillator has a tuned circuit (inductance+capacitance) to determine the frequency. When the inductor is tapped to give the required phase-shift for oscillation it is a Hartley oscillator. When the capacitance is tapped it is a Colpitts.
what is an inductor used for
Since we know that inductance of an inductor depends on the length of inductor by the formula L=muAN*N/l, where l is the length of inductor. So by varying the length of inductor we say that inductance of inductor varies.
an Hartley oscillator uses a tapped inductor ( i.e an inductor with an additional connection at a suitable position in turns of the coil. ) with a specific tap ratio as per the circuit gain and design. For Low Frequency oscillators large inductances are required which have large number of coil turns. It is possible to get suitable ratios for such values hence this circuit is prefered.
In an ideal inductor, no, there is no voltage induced across an inductor unless the current in the inductor is changing. However, since there are no ideal inductors nor power supplies, eventually an inductor will draw a constant current, i.e. the limit of the power supply; and, since no inductor has zero ohms at equilibrium, that current will translate to voltage.
any conductor wound with few turns can be considered as an inductor
An inductor looks like a piece of wire to DC. It will thus look like a resistor, and inductor properties do not apply.
A changing current through an inductor induces a voltage into the inductor, the direction of which always opposes the change in that current.So, in a d.c. circuit, an inductor will oppose (not prevent) any rise or fall in current, although the magnitude of that current will be determined by the resistance of that inductor, not by its inductance.In an a.c. circuit, because the current is continuously changing both in magnitude and in direction, it acts to continuously oppose the current due to its inductive reactance. Inductive reactance is proportional to the inductance of the inductor and the frequency of the supply. The vector sum of the inductive reactance of the inductor and the resistance of the inductor, is termed the impedance of the inductor. Inductive reactance, resistance, and impedance are each measured in ohms.
a coil. a component having the property of inductance.
In DC inductor is short circuited .
The fundamental purpose of an inductor is to store electrical energy in a magnetic field.
The inductor symbol resembles a coil of wire of 3 to 5 turns.