when the magnitude of voltage of a source is controlled by another small voltage source in the circuit the former is called voltage controlled voltage source and the later is called controller voltage source.
Step voltage is a type of AC voltage where the voltage signal represents a flat step up and then a flat step down.
Line voltage is understood as the voltage that the device or appliance needs to operate on. It is also referred to as the devices working voltage. Once the proper line voltage or working voltage is applied to the device it may be transformed to different voltages for different internal component circuits.
Another name for average voltage is the RMS (Root Mean Square). This is a voltage derived from the peak to peak voltage multiplied by .707. If the peak to peak voltage is 170 volts then the average voltage (RMS) would be 170 x .707 = 120 volts.
The MAXIMUM rated voltage is the voltage at which the electricity would arc across the insulators The usage voltage is lower than the rated voltage (usually somewhere around 80% The lightning arrestor voltage is in between. It will not pass current at the usage voltage, but will pass current when the voltage exceeds the arrestor threshhold
110-120 Volts BUT IN SOME AREAS 220.
It is 120V/60Hz
110-120 volts
Yes. The USA has the same voltage of Mexico but in some areas it is 220 volts! So you will need to buy a converter.:)
Mexico uses the 120V/60Hz standard. You should be aware that when plugging older appliances, they most surely would require a a voltage regulator.
Voltage is the potential difference between the source & any point in the circuit. The forward voltage is the voltage drop across the diode if the voltage at the anode is more positive than the voltage at the cathode (if you connect + to the anode). Voltage drop means, amount of voltage by which voltage across load resistor is less then the source voltage.
Voltage gain is the ratio of the output voltage of an amplifier to its input voltage.
bucking voltage is a voltage which is of opposite polarity to the voltage it acts .
Voltage Stabilizer is also called Automatic Voltage Stabilizer or AC Voltage Stabilizer or Voltage Regulator. Actually an automatic voltage stabilizer is designed to automatically maintain a constant voltage level, with protections of equipment against voltage surges, over voltage, under voltage, smoothing impulsive noise.
the difference between a voltage converter to a voltage regulator,is that a voltage converter,converts or changing the desired voltage to be used while the voltage regulator,regulates the input of the voltage amount not to excess to its inputs.
the device oprates on the minimum voltage. in this voltage is called threshold voltage.
There is no formula to convert voltage. Voltage is universal.