Trouble code P0773 means:Shift solenoid E electrical
It is reset with a OBD2 scan tool, after the repair of the system.
An onboard diagnostic scan would be a good first place to look.
The port should be under the steering wheel at very end of the plastic shield.
I have toyota camry 2003se. There is no communication obd2. Scan doesn't connect. Tested all wires, from obd2 connector to ecu, replaced ecu to test, ecu ok.
After repairing the cause for the code, you can clear code with a scan tool.
The check engine light is reset with a scan tool after repairing the failure that caused the trouble codes.
It is on because the ECU has detected a problem with the emissions system. Have the system scanned with an OBD2 scan tool to retrieve the code that has been set. This code will tell you what part of the system is being effected. Not necessarily the defective part but what part is being effected.
After repairing the cause of the code, you can clear it with a scan tool.
need factory scan tool or aftermarket scan tool need factory scan tool or aftermarket scan tool
the correct way is to use an OBD tool, and clear the codes out of the computer. you can also disconnect the negative terminal on the battery for 5 min. i am baffled as to why you would want to clear the code and not find out what the problem is, if the light is on, you can take it to autozone and they will scan the computer too see what the problem is with the car. .
The best way: Take it to your local retail auto parts store. Most of these stores will plug in their scan tool and tell you what turned on the light. If it is something that just needs to be reset they can do that also. If it is something that will just turn the light back on they will tell what the code says, you will have to get the problem fixed so the light will go out.
With a scan tool.With a scan tool.