provides emf and direction of flow of current
To increase the surface contact area, to decrease the resistance of connecting points, otherwise connecting points will damage due to corrosion.
All ya gotta do is unfold a paper clip, put it on a battery, and wait. Make sure it touches the top and bottom.
Plastic clips can be used for a variety of things as they come in different styles. For example, there are plastic clips used to clip back hair and there is also clips that are used to clip together important news articles or paper files.
A CR2032 lithium battery is a small button sized battery often used in PC's, calculators and watches. It is not possible to recharge this kind of battery. They are designed only to be used and then replaced with a new battery.
Clip lamps are frequently used with study, hobby, and drafting tables. Due to their flexibility and freedom in positioning, they can offer superior lighting for people such as architects and illustrators. Mini-clip lights also exist, which are used by readers to obtain good reading light wherever they may be.
1 milligram
it operates a battery,mostly a 9 volt battery
Yes you do need a battery because the paper clip is usually used for an alternative for a wire and the paper clip is what the electricity travels through, so yes you do need a battery.
Its not known
Connect the positive clip of the battery charger to the positive terminal on the battery. Connect the negative clip of the battery charger to the negative terminal on the battery. Select the charge rate you desire either 2,4, or 6 amp. The newer battery chargers will let you know when it is fully charged.
yes it is necessary..
You have to pull a plastic clip/lever up until it pops out. That will free your battery. You may have to rock it by pushing down and pulling up to loosen the clip.
Take a Energizer, Duracell, etc. battery (the bigger the bulb the bigger the battery) and a paper clip. Bend up the paper clip to a pretty straight line, and attach one end to the end of the lightbulb. Attach the other end to one end of the battery, and POOF! Light! If the bulb doesn't come on try attaching the paper clip to the other end of the battery. If it STILL doesn't work, get a bigger battery.
It is very easy to replace the battery on a 1994 BMW 318i. The battery can be found in the trunk on the right hand side of the car. All you need to do is to use a screwdriver to take the plastic clip holding the battery in place off. After the clip is removed, take the battery out and then replace with a new one.
Connect the positive clip of the charger onto the positive post of the dead battery. If the battery is located inside of a vehicle, connect the positive charger clip to a grounded surface--like an engine block--on the vehicle.
All the way along when the crocodile clip is connected to a resistor, when the other end of the resistor is connected to the other side of the battery.
the seats in the passenger side that you sit on come of, they clip in so quick tug and you can get t battery
Take the hot (red/positive +) side jumper clip and clip it to the red battery screw at the battery. Take the Left (black/negative - ) side Jumper clip and clip it to the big bolt attached to the engine (or any othe negative metal connection). On the other car giving you a boost you can do the same connection or just connect to both battery positive and negative top or side connections.