0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the difference between flange mounted and foot mounted electric motor?
The foot-mounted version is also commonly referred to as B3 motor. The DR motor is available with a NEMA "C-face" flange . The "C-face" flange-mounted motor is a motor type with tapped holes in the flanged end shield.
How do you change a Chevy truck thermometer?
remove top rad hose on motor and then the coolant flange the thermostat is under the flange
What is frame size of flange mounted electric motor?
Depends on the motor size and the face type...of course.
Can a foot mounted motor be used as a flange mounted motor What will be the effect?
Trouble is to get it mounted right. It'd be very rare to find an assembly spot set up to accept both flange mount and foot mount. But assuming the motor spec is the same (power, RPM, etc) it'll work just find assuming you get the alignment right.
Where can you run the motor identification numbers?
On the drivers side of the engine just behind the valve cover. They are cast into the bellhousing flange.
Where is sender unit on VW golf se 1996 1781cc?
Typically adjacent to the oil filter flange, and on the end of the motor.
How do you take out the blower motor in a Nissan Versa 2009?
1. Remove the instrument panel and pad. 2. Remove the right side ventilator duct. 3.Disconnect the blower motor connector. 4. Push the flange holding hook toward the blower motor, then rotate the blower motor clockwise and remove it from the A/C unit assembly. 5. Installation is the reverse of removal, noting the following: 6. Rotate the blower motor until the blower motor flange holding hook locks securely in A/C unit assembly.
What is SOFF flange?
Slip-On Flat Face Flange. It means the face of the flange, the surface the physically touches the next flange is flat as opposed to raised (SORF Flange)
What is a swivel flange?
it is a flange that's it
What is the Fastest Small Block Ford?
That Boss 302, was a pretty amazing motor.
Is companion flange same as threaded flange?
No
Where is the serial number on a 4.3 vortec engine?
Block ID number is on the very rear upper bell housing flange and the serial number is stamped into the front boss just above the water pump inlet. Or where the pump bolts to the block. It's a flat boss.
