The glass of a kerosene lamp while glowing is hot. When water falls on it, there is a sudden change in temperature, which causes the glass to break.
Check the wire that goes to your break light. Somewhere along the circuit it is grounded before the lamp and after the switch. Look on the circuit from the switch to the lamp. What is happening is, the circuit is good up to the time that you apply the break. This closes that brake light switch, When the switch closes it sees the dead short and not the lamp. The breaker popping is protecting the circuit wiring from burning up.
Because it is a type of lamp.
You can convert a clamp on desk lamp to a lamp with a regular base by purchasing a tabletop bracket for the lamp. This bracket can act as a base for the lamp.
a pole with a lamp on it.....
The Spongebob Squarepants School Study Lamp is a study lamp made of metal that will not break if the kids get feisty!
A Stego-breakas!
on the pink lamp
The lamp is a piece of equipment that is built into your LCD TV. This lamp is what brightens the screen on the television. The bulbs for this lamp can break and need to be replaced.
tke a screwdriver and remove the screws and take out the tail lamp. otherewise take a hammer and break the tail lamp
break lamp
a lamp. and for the love of God, stop putting brady bunch questions in the new England patriots section.
The park lamp fuse on a Ford Escape is located in the main fuse panel, near the hood release. It prevents the lamp from drawing too much current and will break under excessive load.
The glass of a kerosene lamp while glowing is hot. When water falls on it, there is a sudden change in temperature, which causes the glass to break.
I am not sure that you know what you are asking. To heat something manually is to hold it in your hands and warm it up to your own body temperature; that is not hot enough to break a lava lamp. The only thing you can destroy with your own body heat is a snowflake. But I don't think that's what you really mean. If you are going to position your lava lamp over a candle, then yes, you might break it. What's wrong with using the built-in light, did it burn out?
if the copper wire (s) were conneting the battery to the lamp removing one of the wires would break a circut and the lamp goes out.
A break in the earths crust is called 1.) deformation 2.) boundry 3.) rebound 4.) fault I'll give you a hint. "It was not my _______ !!" "I did not break the lamp!!"