0
What else can I help you with?
Where is the cam sensor located on a 94 Oldsmobile ciera cutlass s?
The 1994 Oldsmobile Cutlass cam sensor is located on the back of the left cylinder head. The cam sensor should be labeled as such.
Where is the speed sensor located on a 1994 cutlass ciera?
where is cam senor on a 91 cutlass ciera 3300
Where is the cam sensor for a 1990 Oldsmobile cutlass ciera?
i have a 90 cutlass ciera with a v6 3300 and just replased that. it is called a combanation sensor. its the crankshaft and cam together located at the back of the harmonic balancer attached to the block. it has 2 bolts on the right side holding it to the block a one in the middle to hold the sensor in place and the sensor sits in it and faces the harmonic balancer on the back of the interrupter rings
Where is cam sensor on 92 Oldsmobile 98 regency?
passengers side behind harmonic balance pulley bottom of engine.Put on lift take off tire makes job easier
Does a 1985 Oldsmobile 2.5 engine have a gear driven cam?
Yes.
Can you put 350 heads and cam on a 307 Oldsmobile engine?
You can put Oldsmobile 350 heads on an Oldsmobile 307, if the 307 is 1984 or older. It will take some work but it can be done, I know for a fact that it can, because my 307 has 350 heads on it. It runs great. I'm not sure about the cam though.
Will a Chevy 350 cam fit in an oldsmobile 403 block?
NO. Not even close.
What is the repair cost of 1992 Oldsmobile eighty eight cam sensor?
cam sensor cost around 28.00 if you put it in. Not hard one bolt.
What battery type for 1994 Oldsmobile Cutless Supreme?
The battery type for a 1994 Olds Cutlass Supreme>> original to the car is a Delco Freedom battery, Battery size 3100 V6..............................................................................525 CCA Twin Dual Cam (DOHC) 3.4L V6..........................................690CCA usually side mounted posts
Where is the cam shaft sensor on a 1989 Oldsmobile 88?
in the intake where the dist. should be on the front of the engine
Fuel pump replacement instructions and type on 1983 Oldsmobile cutlass?
Mechanical engine mount? Remove old one Install new making sure cam is under lever to activate replace mounting gasket and fuel lines Mechanical engine mount? Remove old one Install new making sure cam is under lever to activate replace mounting gasket and fuel lines
Where is the cam positioning sensor on an 1987 Olds Cutlass Ciera with a 3.8 V-6?
the cam position sensor is just below the water pump pulley in the front timing cover. Master
