A closed circuit in which the current divides into two or more paths before recombining to complete the circuit.
It is called the loopdie loop circut.
When the lamps are in a loop, one after the other: we call this a series circuit.
It will oscillate if the loop gain exceeds 1 when the phase difference round the loop is 360 degrees. The frequency of oscillation is set by the loop phase being equal to 360 degrees.
An incomplete circuit is an open circuit; i.e. some part of the circuit isn't connected to anything.Or think of it like this: A circuit is complete when there exists a complete (or closed loop) path for the electrons to flow through it. Also known as a closed circuit. If this is not the case, then it is an incomplete (or open) circuit.
A simple circuit consists of a source of electro motive force ( EMF or voltage V ) This could be a battery,dynamo or solar cell. The circuit should do something, like light a lamp. For the lamp to glow there must be a flow of electrons called an electric current measure in Amperes (I). For the current to flow the circuit must form a closed loop, like a daisy chain. A switch is a device that breaks this loop and controls the state of the circuit. Closed circuit, switch closed, = lamp on Open circuit, switch not closed = lamp off
I guess Electric Circuit....
It is called the loopdie loop circut.
A Series circuit
A circuit in which all parts are connected in a single loop
In a single loop circuit (series circuit) this will be an open circuit. If there is a current loop of some type, there's a complete path already, and thus no classification such as open or short circuited. It simply an incomplete circuit.
Another word for closed circuit is a loop.
That is described as a circuit in series, as opposed to a circuit in parallel, in which there is more than one loop.
DC = direct current.
You probably mean, What is a circuit?It is something that goes in a loop like an electrical circuit, the electrons flow in a loop. A hydraulic circuit, the fluid flows in a circle from one point then back again.
In a circuit, the purpose of a switch is to control the current flow to the load by opening the circuit (off) or closing the circuit (on). When the circuit is open, the is no complete loop through which the current can flow. When the switch closes the circuit, it restores the loop, and thus allows the current to flow.
an open circuit.
A series circuit only has one loop