0
A class 1 division 2 light fixture is one that will not create an explosive hazard in an environment where combustible or explosive gases may be present.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the DOT hazard class 4 division 1?
Class 4 division 1 (more properly called Division 4.1) is for flammable solids.
Class 4 division 1 Dot hazards?
Class 4 division 1 (more properly called Division 4.1) is for flammable solids.
Liquid fueled rocket motors are and example of a class 1 division 3 explosive?
Class 1 Division 3 explosive
What type of material is found in class 2 division 1?
DOT Class 2, Division 1 (more properly called Division 2.1) is for flammable gases.
How do you remove the tail light lens from a 1989 Chevy Celebrity?
The tail light lens on a 1989 Chevy Celebrity is part of the tail light fixture and cannot be conveniently removed. If you want to change a light bulb you have to remove the tail light fixture from the car. To remove the tail light fixture: 1. In the trunk next to the quarter panel are three nuts, remove the center nut. It should be in the center of the tail light fixture. 2. Pull the tail light fixture so that the stud comes out of the body, then pull outward to pull the tab out of the backup light fixture. 3. You can now take the appropriate socket out and replace the bulb. Reverse the steps to replace the light fixture.
What type of material is found in DOT class 2 division 1?
DOT Class 2, Division 1 (more properly called Division 2.1) is for flammable gases.
What are Dot class 6 division 1 materials consist of?
DOT class 6 division 1 materials consist of poisonous materials.
What is class 4 division one in the DOT hazard?
Class 4 Division 1 (more properly called Division 4.1) is for flammable solids.
Class 4 division 1?
flammable solid
How do you change the rear brake lights on a 1988 Chevrolet Celebrity?
To change the tail light bulb on a 1986 to 1989 Chevy Celebrity coupe or sedan: 1. In the trunk by the appropriate quarter panel there are three nuts, the middle nut holds the outer end of the tail light fixture in place. Remove that nut, it should align with the middle of the tail light fixture. 2. Pull back on the tail light fixture until the stud comes out of the body. Then pull slightly outward on the tail light fixture to pull a tab out of the backup light fixture. 3. Locate the appropriate socket for the bulb you are going to replace and remove the socket from the tail light fixture. Put in the new bulb and reverse the instructions to put the tail light fixture back in place.
What is class 1 division 6 of the DOT hazard classification system?
Poisonous materials are found in DOT division 6.1.
What hazardous material is DOT class 4 division 1?
division 4.1 is flammable solids
